Tile Redi redi DOOR 5400 Series User manual

RDQCI5400T-01042021
INSTALLATION MANUAL
DOOR
®
redi
SERIES: 5400
PanelCONFIGURATION:

2RDQCI5400T-01042021

3RDQCI5400T-01042021
A B C
D E F
Side Rail Top Rail Cap Panel Side Strip
Anchors Screws Support Bar
DRILL BIT (Ø 1/8”, Ø 1/4”)

4RDQCI5400T-01042021

5RDQCI5400T-01042021
A
60”
1
2A
D
E
1
2
3
4
¼”
Place your side rail (A) against your desired wall. After confirming your position with a level, mark
your wall through the frames pre-drilled holes. Your side rail should be placed a minimum of 1/2”
from the edge of your bathtub.
Remove the side rail from the shower enclosure and drill into your pre-marked holes. Insert
anchors (D) into the wall using a rubber mallet.
Cut your side rail (A) to 60”.

6RDQCI5400T-01042021
C
F
D
E
C
F
D
E
C
F
D
E
C
F
D
E
Now place your side rail (A) back into your shower enclosure and screw your frame into place using
the provided screws (E).
To protect the glass please make sure to leave the corner protectors until after the item has been in-
stalled.
Wedge the Panel Side Strip (C) along the inside of the Side Rail securing the glass panel in place.

7RDQCI5400T-01042021
F
D
E
¼”
5
To install, find the Support Bar (F) loosen the Support Bar Screws and dry fit the Support Bar
assembly as shown. Take the Wall Mount side and make it flush against the wall. Mark the
locations of the Panel Mount and the Wall Mount, and then remove the Support Bar assembly.
Using the Wall Mount, mark the location of the pre-drilled holes on your support wall. Drill the
holes using a ¼” drill bit.
Place wall anchors into the holes and proceed to screw the Wall Mount into place.
Remove the Panel Mount and place one end of the Support Bar into the Wall Mount. Slide the
Panel Mount onto the Support Bar and position the angle adjuster so it fits onto the panel.
Finally, tighten all screws.

8RDQCI5400T-01042021
B
Proceed to install the Top Rail Cap (B) as illustrated.
Apply some silicone to the outside edge of the shower enclosure (between the wall profiles and wall,
and between the frame and the shower pan) to ensure a waterproof seal. After installation, allow 24
hours for silicone to cure before being used.

9RDQCI5400T-01042021
4450 NW 126 Avenue, Suite 101, Coral Springs, FL 33065
800-648-9212 | [email protected]
www.tileredi.com
Tile Redi® and Redi Door® trademarks and logos are owned by and the Intellectual Property of Tile Redi, LLC.
©2021 Tile Redi, LLC. All Rights Reserved.
DOOR
®
redi