Timbercity Kiddie's Chair User manual

Kiddie’s
Chair
www.timbercity.co.za
Your Project Partner
Assembly Instructions
CUT LIST
SupaWood 16 mm
Chair back 1 x 500 mm x 250 mm
Chair front 1 x 218 mm x 250 mm
Top and bottom 2 x 250 mm x 250 mm
Bottom strips 2 x 50 mm x 250 mm
YOU WILL ALSO NEED
35 mm chipboard screws
Wood glue
Wood ller
Paint
Neat design allows
2 chairs to ip-and-stack
Chair is sized to t our Kiddie’s Desk design
500 mm
250 mm
250 mm
250 mm

www.timbercity.co.za
Your Project Partner
Step 1
Join the top (250 mm x 250 mm) x 1 and bottom of the
chair (250 mm x 250 mm) x 1 to the front (218 mm x 250
mm) x 1. First drill pilot holes for the screws, then counter-
sink them, before applying wood glue and fastening the
pieces together with screws.
Step 2
Step 3
You are now ready to join the back of the chair (500 mm
x 250 mm) x 1 to the U shape you created in step 1. Again
drill pilot holes, then countersink them, before applying
wood glue and fastening the pieces together with screws.
Now join the two bottom strips (50 mm x 250 mm) x 2
to the bottom of the chair. Position them about 10 mm
in from the back and front of the chair. Drill pilot holes,
countersink them, apply wood glue and fasten with
screws. Finally, ll the screw holes with wood ller, allow
to dry, then paint your chair in the colour of your choice.