TimeTec Water Leak Detector User manual

www.i-timetec.com
User Guide
WATER LEAKING DETECTOR
ELIMINATE THE RISK OF LEAK

2
www.i-timetec.com
Smoke Detector
INTRODUCTION
TimeTec Water Leak Detector uses the wireless Zigbee technology,
with extra-low power consumption that prolongs the battery lifespan.
Its detached design for detector and sensor aims to prevent product
damage under a high humidity environment. It is recommended to
place the detector at the basement, machine room, guesthouse, water
tower, reservoir, pool, swimming pool, kitchen and toilet. With its high
accuracy and hypersensitive sensor, this detector is efficient in detect-
ing water leakage, overflow or overshot water level. Users will be noti-
fied via i-TimeTec App when any damaging leaks occur.

3
www.i-timetec.com
Smoke Detector
TECHNICAL SPECIFICATION
Detector Size:60*30*12.5mm
Sensor Size: 28.3*26.5*12.2mm
Working Temperature: -15C - +60C
Working Voltage: DC3V(One CR2450 Button Battery)
Standby Current: ≤10uA
Alarm Current: ≤30mA
Wireless Communication Protocol: Zigbee
Communication Coverage: ≤ 15m (without barrier)
Ambient Temperature: Maximum 95%RH

4
www.i-timetec.com
Smoke Detector
INSTRUCTION
1. Install the TimeTec Water Leak Detector at places that have a higher risk of water
leakage.
2. Do not place the Detector at places that are shrouded with soot and water va-
pour.
3. Do not install the Detector at places that have been submerged in water.
Network Button
Indicator Light
Sensor Detector Installation Base

5
www.i-timetec.com
Smoke Detector
INSTALLATION OVERVIEW

6
www.i-timetec.com
Smoke Detector
INSTALLATION
Step 1
• Log in to your i-TimeTec App account on your
smartphone.
• In the main menu page, select “+” to Add De-
vice, then scan the QR code on the device.
• Add the device to the TimeTec Smart Gateway
or TimeTec Smart Camera Gateway.
Step 2
• After the Water Leak Detector has been add-
ed, remove the insulation sheet to power the
device.
Step 3
• Press the network button to connect the De-
tector to the Gateway. The indicator light will
turn green once it has been successfully con-
nected.
• Hold the network button for no less than 10
seconds to turn it off. Release the button to
exit the network.
• For any network changes that are causing De-
tector connection failure, please exit the net-
work and reconnect it again.

7
www.i-timetec.com
Smoke Detector
Step 4
• Remove the back membrane from the
double-sided tape, adhere the Device
on the designated area.
Step 5:
• Place the Detector at the installation
base.

© 2020 Timetec Cloud Sdn Bhd. All rights reserved • 012020
www.i-timetec.com