TS-D1000-EXEXTENSION UNIT
INSTRUCTION MANUAL
Thank you for purchasing TOA’s Extension unit.
Please carefully follow the instructions in this manual to ensure long, trouble-free use of your equipment.
1. SAFETY PRECAUTIONS
• Before installation or use, be sure to carefully read all the instructions in this section for
correct and safe operation.
• Be sure to follow all the precautionary instructions in this section, which contain important
warnings and/or cautions regarding safety.
• After reading, keep this manual handy for future reference.
Indicates a potentially hazardous situation
which, if mishandled, could result in death
or serious personal injury.
WARNING
• Do not expose the unit to rain or an
environment where it may be splashed by
water or other liquids, as doing so may
result in re or electric shock.
• Use the unit only with the voltage specied
on the unit. Using a voltage higher than
that which is specied may result in re or
electric shock.
• Do not cut, kink, otherwise damage nor
modify the power supply cord. In addition,
avoid using the power cord in close
proximity to heaters, and never place heavy
objects -- including the unit itself -- on the
power cord, as doing so may result in re or
electric shock.
• Avoid installing or mounting the unit in
unstable locations, such as on a rickety
table or a slanted surface. Doing so may
result in the unit falling down and causing
personal injury and/or property damage.
• Since the unit is designed for indoor use, do
not install it outdoors. If installed outdoors,
the aging of parts causes the unit to fall
off, resulting in personal injury. Also, when
it gets wet with rain, there is a danger of
electric shock.
• Should the following irregularity be found
during use, immediately switch off the
power, disconnect the power supply plug
from the AC outlet and contact your nearest
TOA dealer. Make no further attempt to
operate the unit in this condition as this
may cause re or electric shock.
· If you detect smoke or a strange smell
coming from the unit
· If water or any metallic object gets into the
unit
· If the unit falls, or the unit case breaks
· If the power supply cord is damaged
(exposure of the core, disconnection, etc.)
· If it is malfunctioning (no tone sounds)
