TOHATSU 8 User manual

Copyright © 2007 Tohatsu Corporation. All rights reserved. No part
of this manual may be reproduced or transmitted in any form or by
any means without the express written permission of Tohatsu
Corporation.

3-2.
Installing
the remote controldevices
It is recommended
to consult with your dealerfor installationand
adjustmentof the
remotecontroldevice.
(
1)Installationof the
Remote
ControlCables
(Boxside)
Followthe instructionmanual
provided
with the
remotecontrol
box.
(2)Installationof the
Remote
Control
Box onyourboat
Followthe
instructionmanual
provided
withthe
remote
controlbox.
(3)
Installing
of theRemoteControl
Assembly
(WiringHarness)
@ nittingof connecting
parts
to
cables
Screw
the tip of the remote
controlcable
intothecable
joint
up to approx.
10mm (0.39
inch),thenlock them
with a
lock nut. Here,apply grease to
theholeof thecable
joint.
@ Fitting of RemoteControl
CabletoEngine
Cable
(engine
side)
andthe Cord
| \ \c"o,"Harness
l\
ShiftCable ThrottleCable
Note:
Put
the
control
leverontheNeutral
position
and
theNeutral
warm-up
lever
inthe
fullyclosed
position.
4
Remote control cable
Approx.10
mm
(0.39
inch)

Note:
Confirm
whethertheenginesideshiftis in gear
when
shiftingthe
control
lever
ofthe Remote ControlBoxto itsfirst
position
in Forward
or Reverse
(about
32") andwhetherthe throttle of the carburetor is
fully
open
when
shifting
theleverfurther.
Confirmwhetherthe carburetor'sthrottleis fully
closedwhenthe
control
leveris
shifted
totheNeutral
position.
@ ConnectingtheCordassembly
(Wiring Harness)
PasstheCord assemblyfrom the Remotecontrol box throughthe hole
in the Lower motor coverandcoverthe wire endswith the Sleeve
(provieded
in a tool bag)andthenconnectthe electric
terminals
according
tothedrawingbelow.
And alsoprotect the batterycords andthe cableharnesswith the
protective
tube,and then fix the tube with the bandand the clamp. (a
protective
tubeandaband are
providedin atool bag)