Toro Style Lites User manual

1. Press the bulb into the fixture contacts.
2. Snap the silver reflector into the clear lens.
3. Install the fixture lens/reflector.
Install the clear lens/reflector by pushing down on the lens with
slight pressure while turning the lens clockwise. The tabs on the
lens will snap into the three slots on the fixture. Turn the lens until
the movement stops.
INSTALLATION
GUIDE
FORM NO. 3315-919
MODEL NO. 52201 39000001 & Up
Style Lites™ Floodlights
®
4. Prepare the stake.
Loop the cable around the channels in the stake. Make certain the
cable is centered around the stake head and is tight. If the cable is
loose, pull the ends to eliminate the slack.
Imprinted
triangles
6. Align the side of the stake with the imprinted triangle to
the top of the fixture head with the imprinted triangle.
5. Make sure the piercing points in the fixture are
straight.
Make sure the brass piercing points in the cable channel at
the base of the fixture are straight. Even a slight bend may
result in contact not being made with the wire.
Misaligned
Piercing
Points
Correct
Piercing
Points
The most important
part of installing the
fixtures is making
sure their metal pins
pierce the wire inside
the cable:
You’ll know they’re
well-aligned and the
wire was pierced
when the light
comes on.
This
Not This

9. Put the stake into the ground.
To install the stake, make a hole in the ground. Do not push the
stake into the ground without making a hole first because the
stake could be damaged. After you’ve inserted the stake, fill in
around it with dirt. Do not hammer or press hard on the lamp
assembly.
10. Adjust the light beam.
To adjust the light beam from narrow to broad, turn the lens
using the tabs.
WARNING
! Possible Burns !
Do not attempt to remove any bulbs while the fixtures are on or you may be burned.
Lens Tabs
1
o'clock
Imprinted
triangles on
the stake
and the
fixture
7. Hold the stake with the cable at an angle of about 30°
(1 o'clock) to the floodlight housing as shown.
Press the stake with the cable down firmly into the piercing points
on the fixture.
If you have done this correctly, the fixture should light. If it doesn’t,
make sure the power pack is on (and the photocell is covered to
block light), the piercing points are straight, and try again. You
can reposition the cable; the earlier holes created by the piercing
points will self-seal and not cause a hazard.
8. Lock the stake in place.
After the fixture has lit, turn the stake away from the imprinted
triangle on the fixture to lock it in place. Pull on the cable to
remove any slack.
IMPORTANT: To ensure your power pack isn’t overloaded,
use a replacement bulb with the same wattage as the original
bulb. Maximum wattage allowed for this fixture is 7 watts.