Toshiba 40WL753B Quick start guide

How to upgrade the Software
1 Connect the AC power and turn “ON” the TV receiver.
2 The USB reader is located on the left or right of the cabinet near the side control/jack assembly as
shown in Figure1.
Figure1
3 Insert the “USB Drive” into the USB slot as shown in Figure2.
Figure2
4 After insertion of USB Drive into reader slot a firmware upgrade information window will appear as
shown in Figure3.
Figure3
Copyright2010AllRightsReservedPage1of2

5 If the window is no present, remove the USB Drive and try reinserting the USB Drive again.
Start the software upgrade by using the “left or right arrow” key of the remote control to select “Yes”.
Press “OK” key of the remote control to begin the upgrade.
8 software upgrade, the TV receiver will display
y remote keys or buttons
n the television unti
6
7
The software upgrading process will begin. During the
“Updating… don’t AC power off” as shown in Figure4.
During this time, do not remove power to the television or press an
o l the upgrade is complete!
Figure4
Upon completion of the sof 9tware upgrade a message will appear as shown in Figure5.
Figure5
0 Remove the “USB Drive” from the slot.
1 The TV will turn OFF and then, turn ON automatically.
2 TV.
Refer to your Owner’s manual should you have any questions.
1
1
1Perform the “Initial Setup” and set “Personal Preference” of the
Copyright2010AllRightsReservedPage2of2