Touchboards PM2-S-XL User manual

Mount PM2-S-XL
Assembly Instructions
www.video-furn.com 288 Don Hillock Drive |Aurora |Ontario|L4G 0G9 |
1.877.834.3876 v1.0

Parts
Included
Hardware
Included
Tools Required
Not Included
PM2-Mount
HW Bag
x1
TV 52-70
HW Bag
x1
Basic
Wrench or
Socket set
10-32
Nut
x2
M8x12mm
SHCS Bolt
x2
M6x10mm
SHCS Bolt
x3
M10
Nut
x2
Camera Bag
x1
TV Brackets w M8 Bolts
x2
Base Base washer
Wide camera plate Tube Locker 2x1x45” TUBE
Main Pillar
Camera Neck
M8 Hex key
x1
M6 Hex key
x1
Drillbit 10mm or 13/32
x1
2” Hole Saw
x1
Drill + Philips
Screwdriver
TV VESA patterns up to 1100mm x 650mm
Max TV Weight 200 lbs.

Step 2
Attach main pillar
Step 1
-Center Base approx. 2” from back of furniture. Preferably over grommet.
-Check position from underneath/inside unit for interference.
-Using Base as Jig, Drill 10mm or 13/32” holes. Some AVFI carts are predrilled.
-Use a 2” hole saw or Jigsaw to open center hole/cable passage in furniture.
M10
Nut
x2
Base washer
Holes at
the back

Assembly Instructions
www.video-furn.com 288 Don Hillock Drive |Aurora |Ontario|L4G 0G9 |
1.877.834.3876
Step 3
Insert Tube and lock.
Step 4
Attach brackets to TV
Using Hardware found in:
TV 52-70
HW Bag
M8x12mm
SHCS Bolt
x2
Tube Locker
TV VESA patterns up to 1100mm x 650mm
Max TV Weight 200 lbs.

Step 5
Hang TV on mount.
Adjust height if
Required. See step3.
Assembly Instructions
www.video-furn.com 288 Don Hillock Drive |Aurora |Ontario|L4G 0G9 |
1.877.834.3876
Step 6
Attach camera mount
10-32
Nut
x2
M6x10mm
SHCS Bolt
x2
Use camera bag
to attach camera.
M8 Bolts already
On bracket
x2

Step 7
Cable management and accessories
Assembly Instructions
www.video-furn.com 288 Don Hillock Drive |Aurora |Ontario|L4G 0G9 |
1.877.834.3876
M6x10mm
SHCS Bolt
x1
Most Accessories will center mount
On the back of the Pillar using the
extra M6 bolt.
Other accessories can hang on the
tube or mount under the TV
brackets.
Most Cable Management should be
run through the pillar down into the
furniture.
The grommet on the bottom back is
removable to help guide the cables.
End.