TP Toys TP880 Nagano Quick guide

TP880 Nagano
TP877 Himalayan
TP883 Woburn
Instructions for assembly, maintenance and safe use.
Please retain for future reference.
Robovision Ltd t/a TP Toys
Unit 11, Enterprise Way, Flitwick, Bedfordshire, MK45 5BX England
www.tptoys.com
THIS PRODUCT CONTAINS SMALL PARTS AND IS NOT SUITABLE FOR CHILDREN UNDER 36 MONTHS.
CONTAINS SMALL PARTS. CHOKING HAZARD.
ONLY FOR DOMESTIC USE. FOR OUTDOOR USE.
TOY MUST BE ASSEMBLED BY AN ADULT BEFORE USE.
ADULT SUPERVISION IS REQUIRED
CHILDREN MUST NOT USE THE EQUIPMENT UNTIL PROPERLY INSTALLED.
REMOVE ALL PACKAGING BEFORE GIVING TO YOUR CHILDREN.
THIS PRODUCT IS INTENDED FOR USE BY CHILDREN FROM AGES 3 TO 12 YEARS.
ANCHORS THAT ARE SUPPLIED WITH THIS PRODUCT MUST BE FITTED BEFORE USE.
MAXIMUM COMBINED USER WEIGHT FOR SWING FRAMES 200KGS
TP880 NAGANO SINGLE SEAT USER WEIGHT - 60KGS GLIDE RIDE USER WEIGHT - 35KGS PER SEAT
TP877 HIMALAYAN NEST SWING USER WEIGHT - 120KGS
TP883 WOBURN SINGLE SEAT USER WEIGHT - 60KGS GLIDE RIDE USER WEIGHT - 35KGS PER SEAT
WARNING!
x2
TP880 Nagano TP877 Himalayan TP883 Woburn
Build Time
2 Hrs
TP880 TP883 TP877 Roundwood Swings New In8001-A 23.02.18.indd 1 23/02/2018 12:18

TP880 TP877 & TP883
2
Important advice for assembly, maintenance and safe use
1. Toys must be assembled by an adult before use exactly in accordance with the instructions.
2. Check all parts are present before you start to assemble the product.
3. Place small parts on a tray or similar, to ensure they are not lost.
4. If any parts are missing do not use the product until the replacement parts are fitted.
5. Remove all packaging before giving to your children or allowing them to play with this product.
6. Ensure your product is sited on level ground. Failure to do this may put additional stress on connections and joints
and in time could cause them to fail.
7. Ensure your product is located on a soft impact surface like grass. Never locate your product on hard surfaces like
concrete or asphalt.
8. Children must not use this product until properly installed.
9. Adult supervision is required at all times to ensure children play safely. Ensure children’s clothing is appropriate for
the play activity.
10. Equipment should be checked by an adult at the beginning of each season and at regular intervals during the
usage season to ensure it is safe.
11. Pay special attention to all connections and fastenings.
12. Parts may need to be replaced if they show signs of wear and tear. Replace any defective parts in accordance
with these instructions.
13. Any changes to this toy, e.g. changing or adding an accessory, must be done in accordance with our instructions.
Failure to do this will render your guarantee null and void and may make your product unsafe.
14. The age recommendation for this product is clearly stated on the packaging and these instructions. Please adhere
to it at all times.
15. When you dispose of this equipment please do so responsibly.
Safe play free space area
The safe play area refers to the zone extending 200cm
around the toys on all sides and 250cm above the toy.
The safe play area must be free from all obstacles.
Dimensions
2m
2m
2m
2m
TP880
TP877
TP883
276cm
240cm
300cm 300cm 375cm
TP880 Nagano TP877 Himayalan TP883 Woburn
TP880 TP883 TP877 Roundwood Swings New In8001-A 23.02.18.indd 2 23/02/2018 12:18

TP880 TP877 & TP883
3
Know Your TP Round Wood.
Timber is a very popular choice for active outdoor toys. For reasons of affordability and the environment, all wood playset
manufacturers use softwood rather than hardwood. Each piece of timber is unique, bearing its own knots, cracks and
variations in colour.
Round timbers tend to come from younger smaller trees and are complete tree poles, stripped of any bark and other
rough materials but subject to no further processing apart from the application of a suitable environmentally friendly
preservative.
Our round wood frames are rustic in appearance. The heartwood that they are made from naturally has cracks and
splits. Theses cracks will change over time due to atmospheric conditions. When wet, the wood will take in water, swell
and the cracks will close up (not disappear), when dry the wood contracts and the cracks will open up.
Whilst this can sometimes seem alarming, the round timber frames are designed and dimensioned to ensure these
natural characteristics do not have an impact upon the structural integrity of the frame. All of our wooden play frames
are rigorously tested by an independent test house and fully comply with the relevant toy safety regulations.
Because of the natural characteristics of such wood products, it is vital that parents check their play frame regularly to
identify any splintering or lifting of the surface layers of the wood or any exposure of rough wood due to changes in
cracks and splits. Affected areas must be rubbed down using coarse sandpaper to restore a smooth. Safe surface.
Very occasionally these characteristics can develop to a point where replacing the pole may be required. This can be if a
crack is in a particular position or if a crack exceeds certain parameters. Examples of this are:
• Where cracks open up in excess of 5mm in width.
• Where cracks of a significant width extend over half the total length of the timber.
• Where cracks run through fixing points.
TP880 TP883 TP877 Roundwood Swings New In8001-A 23.02.18.indd 3 23/02/2018 12:18

4
TP880 TP877 & TP883
TP880 TP877 TP883 Contents - Please check
5mm
Drill Bit
Step Ladder Spirit LevelTape MeasureMallet
Combi Drill
Pozi #2
Pozi #3
Screwdriver WrenchSockets
10 & 13mm
Spanner
10 & 13mm
MW0200 2700mm x2
801
Not Supplied
MW0202 900mm x2
PR9598
TP880 x2
TP877 x2
TP883 x4
M8 x25mm
FA8440
x16
70mm FA8439
x16
PR5069
x4
40mm FA8380
x6
4 x 16mm FA4527
x2
Fixings - SP0075
Shovel
802 - 1
Please note: There may be some fixings left over after the assembly build.
FB6038
x2
PM1007
Flag x1
MW0203 2250mm x1
803 - 1
MW0201 3000mm x1
Swing Accessories
Swing Seats supplied vary depending on product purchased.
See page 10 for details.
TP928
Lime Seat
TP940
Glide Ride
TP932
Nest Swing
MW0200 2700mm x2
MW0200 2700mm x2
PM1968
x1
880- 2 Nagano / 877-2 Himalayan / 883-2 Woburn
880-1 Nagano / 877-1 Himalayan
883- 1 Woburn
880-3 / 887-3 / 883-3 880- 3 Nagano / 877-3 Himalayan / 883-3 Woburn
Also
Required:
Tools - You will need:
TP880 TP883 TP877 Roundwood Swings New In8001-A 23.02.18.indd 4 23/02/2018 12:18

5
TP880 TP877 & TP883
Swing Arm Assembly
FB6038 x2
FA9598
TP880 x2
TP877 x2
TP883 x4
MW0203 2250mm x1
MW0201 3000mm x1
MW0201
or
MW0203
1
70mm FA8439
x4
M8 x25mm
FA8440
x4
15mm
15mm
2
x2
5mm
Make sure you thread the metal
collars (FA9598) onto your top bar
before the securing the brackets to
each end of the wood
ASSEMBLY TIP
TP880 TP883 TP877 Roundwood Swings New In8001-A 23.02.18.indd 5 23/02/2018 12:18

6
TP880 TP877 & TP883
40mm
FA8380
TP880 x2
TP877 x2
TP883 x4
3
445mm
277mm
Swing Seat Position
450mm
TP883
MW0201 - Triple Top Bar
TP940
Glide Ride
Position
445mm450mm
445mm
573mm
Swing Seat Position
TP880
MW0203 - Double Top Bar
TP940
Glide Ride
Position
550mm
1410mm
385mm
Nest Swing Position
TP877
MW0203 - Double Top Bar
385mm
5mm
A
A
A
A
Locate your swing seats correctly:
Swing Seat Position
TP880 TP883 TP877 Roundwood Swings New In8001-A 23.02.18.indd 6 23/02/2018 12:19

7
TP880 TP877 & TP883
70mm FA8439
x2
MW0200 2700mm x2
M8 x25mm
FA8440
x2
4
5mm
5mm
ASSEMBLY TIP
Step
ladders
required.
70mm FA8439
x2
MW0200 2700mm x2
M8 x25mm
FA8440
x2
5
5mm
5mm
TP880 TP883 TP877 Roundwood Swings New In8001-A 23.02.18.indd 7 23/02/2018 12:19

8
TP880 TP877 & TP883
MW0202 900mm x2
70mm FA8439 x4
M8 x25mm
FA8440
x4
x2
Make sure that the fixing points
are centred on the legs.
ASSEMBLY TIP
6
Generic view of Top Bar only.
Actual Top Bar will vary
depending on product purchased.
ASSEMBLY TIP
5mm
TP880 TP883 TP877 Roundwood Swings New In8001-A 23.02.18.indd 8 23/02/2018 12:19

9
TP880 TP877 & TP883
TP880 TP877 TP883 - Attaching Swing Accessories
TP928
Lime Seat
TP940
Glide Ride
TP932
Nest Swing
Glide Ride and Nest Swing
need to be built before
attaching to the Top Bar.
Please refer to product
instruction manuals supplied
with these products.
IMPORTANT
ASSEMBLY TIP
TP880
TP940
Glide Ride
7
TP928
Lime Seat x2
TP883
TP887
450mm
TP940
Glide Ride
TP932
Nest Swing
x2
x4
ASSEMBLY TIP
Step
ladders
required.
ASSEMBLY TIP
Step
ladders
required.
ASSEMBLY TIP
Step
ladders
required.
TP928
Lime Seat
TP928
Lime Seat
550mm
TP880 TP883 TP877 Roundwood Swings New In8001-A 23.02.18.indd 9 23/02/2018 12:19

10
TP880 TP877 & TP883
PM1007
Flag x1
4 x 16mm Woodscrew x2
FA4527
135mm
350mm
Min
Swing seat height adjustment
PM1968
x1
8
9
1 2
TP880 TP883 TP877 Roundwood Swings New In8001-A 23.02.18.indd 10 23/02/2018 12:19

11
TP880 TP877 & TP883
70mm FA8439
x4
PR5069
x4
x4
Ensure the stakes are
positioned into the
setting Post-Mix concrete.
Warning: Never
set the legs of the
playset in concrete.
Dig holes:
300mm x
300mm x
300mm deep.
Mark leg/hole position.
Not
Supplied.
Fill holes with Post-Mix concrete.Fix stakes to legs.
1 2 3
5 64
x4
TP814
300mm
300mm
300mm
M8 x25mm
FA8440
x4
45°
10
5mm
TP880 TP883 TP877 Roundwood Swings New In8001-A 23.02.18.indd 11 23/02/2018 12:19

Instruction Part No: IN8001 Issue-A 23.02.18
Your TP Guarantee Number/Product Batch No is
Thank you
Thank you for purchasing this product.
Please register your new product on line at tptoys.com
www.tptoys.com/productregistration
Find out about the guarantee for this product,
visit www.tptoys.com/guarantee
For customer services and help with your product,
visit www.tptoys.com/customer/help
TP880 TP883 TP877 Roundwood Swings New In8001-A 23.02.18.indd 12 23/02/2018 12:19