Trackunit 401 DualID User manual

Placement instructions
Practical advice
General Trackunit 401 DualID installation
Do NOT install the GPS/GSM
unit directly under a layer of
metal or next to wires.
Make sure that water can
run off the unit.
1. Mount the bracket on the
machine using 3 screws.
Ø11 mm
3. Click the DualID into the
bracket starting at the top. A
click is felt when pressing
the bottom part of the
DualID firmly in place.
2. Drill a hole in the back
panel for the unit cable and
drag the cable through the
hole. The hole must be big
enough for the plug!
Serial number located on
the back of the GPS/GSM
unit.
GSM number and unit serial
number is located on the
box. Label can be peeled
off and placed on page 4 of
this guide.
+xx xx xx xx xx
S/N xxxxxx
Do NOT perform installation
inside a building.
S/N xxxxxx
Locate the unit as shown
for optimal signal
conditions.
7001.0080 v1.3 06-07-2015
©Trackunit 2015

Trackunit 401 DualID installation
General wiring
Guidelines for correct wiring:
Disconnect the power supply during installation.
©Trackunit 2015
Wire colour Connection Description
Blue Ground Ground
White Digital input 1 Operating hours counter input
Brown Digital input 2 Ignition signal input
Grey Digital Input 3 Not available. Used for DualID Power.
Pink Digital input 4
In case the main switch breaks the ground wire, the
inputs may register a voltage level when off.
To avoid this, the pink wire should be connected to the
chassis of the machine and activate input filter by
setting filtering ‘on’ via the Verify tool. (See page 3)
Yellow Digital output 1 Output activates ground for relay (85)
Red Power
Connect to permanent 12 / 24 / 48V supply
(Absolut max. range 9-65V)
Example showing general installation
Hourmeter
Alternator
7001.0080 v1.3 06-07-2015