Trackunit DualID II User manual

©Trackunit 2017 7006.1201 v2.0 01.05.2017
Using key pad:
1. Type pin code
2. Confirm with
3. Green light in LED3 indicates authorized ID
Begin operation.
Using RFID card:
1. Present card in front of reader
2. A beep signal indicates card is read ok
3. Green light in LED3 indicates authorized ID
Begin operation.
Info:
Yellow light in LED1 indicates the unit has power
Cancel key input with (start again)
Red flash in LED3 when input is cancelled
There is a 10 sec. time out for pin input
Don’t use RFID card and pin simultaneously
LED2 is not in use
Installation check using “Verify my Trackunit”
Action
Screen
Go to : http://verify.trackunit.com/
Login with designated
username and password
Enter serial number of the unit being installed.
Accessories:
protective
bracket
LED indications
LED 1
LED 2
LED 3
Yellow
Power
-
-
Green
-
-
ID ok
Red
-
-
ID cancel
LED 3
LED 1
Keypad and
RFID card
reader
LED 2
User guide
Trackunit DualID II

©Trackunit 2017 7006.1201 v2.0 01.05.2017
Customer care
If you have a problem and cannot find the information you need in the product documentation, please contact
your local Trackunit representative or customer care in your area:
Denmark and other countries:
Trackunit A/S
Telephone: [phone]
E-mail: [e-mail]
Germany:
Trackunit GmbH
Telephone: [phone]
E-mail: [e-mail]
United Kingdom:
Trackunit Ltd
Telephone: [phone]
Email: [e-mail]
Protective Mounting Bracket
Trackunit DualID II
Bracket ordering number 9832.000001