Trade Price Deals 200A User manual

4 LEVEL
BOLT-LESS
SHELVING
UNITS
Instruction manuals
for model numbers:
200A, 200B, 200C, 300A,
300B, 300C, 300D & 300E

Thank you for buying this shelving
unit from Trade Price Deals Ltd.
It is very important that you read and understand these
instructions carefully before attempting to assemble
your shelving. This will ensure the safety of yourself
and others during the assembly process, and will
ensure that your product is used correctly and safely
after assembling.
Please take note of your part number, your universally distributed load
(UDL*) per level and the loading diagram on page 7.
PARTS LIST
200A, 200B, 200C, 300A, 300B, 300C, 300D & 300E.
A B C D E F
*UDL is universally distributed load, or the maximum weight allowed
per level, distributed evenly across the level.
PART NUMBER UDL* MAX WEIGHT PER UNIT
200A, 200B, 200C 200KG 800KG
300A, 300B, 300C, 300D, 300E 300KG 1200KG
NO No & DESCRIPTION QUANTITY
A Upright 8
B Front / Back Beam 8
C Side Beam 8
D Centre Support Beam 4
E MDF Shelf 4
F Upright Joint 4
G Plastic Foot 8
Models 300D & 300E will
have 8 centre support
beams instead of 4.
TOOLS
REQUIRED
Rubber mallet
& flat head
screwdriver
G

ASSEMBLY INSTRUCTIONS STEP 4.
Join the 2 ‘ladders’ together using 4 x front/back beams (B).
STEP 5.
Using upright joints (F) connect the remaining 4 x uprights (A)
to the existing 4 uprights.
STEP 6.
Repeat steps 2-4 to create the top half of the unit.
• Always assemble on a firm, level surface. It is not advisable to
assemble on a carpeted floor.
• It is recommended that assembly is completed by two people.
• Always wear protective gloves when assembling.
• Use a cloth to protect the powder coating when using the mallet to
tap beams into place.
• Always ensure that the tabs on the beams (B & C) fully enter the slots
on the uprights (A).
• Never locate the bottom shelf more than 150mm from floor.
• Always locate top shelf at highest possible position.
STEP 1.
Fit plastic foot (G) to bottom of each upright (A).
STEP 2.
Use 2 x side beams (C) to join together 2 x uprights (A).
Locate beams at height that shelves will be required, creating a ‘ladder’.
STEP 3.
Repeat to create another ‘ladder’, ensuring corresponding
beams are at same height.

STEP 7.
Connect front/back beams (B) using centre support beams (D).
STEP 8.
Bend flexible tabs back on themselves, using flat-head
screwdriver, for maximum rigidity.
GENERAL SAFETY RULES
1. Ensure shelving is always kept in good condition.
2. Always adhere to the maximum UDL for your shelving, as shown on
page 2.
3. If your shelving unit gets damaged stop using immediately.
4. Heavier items should always be stored on the lower shelves. Always
load your shelf from the bottom up.
5. Ensure load is evenly distributed as per diagram below.
RECYCLING
• Always dispose of packaging responsibly and appropriately.
• Cardboard box – widely recycled.
• Plastic sleeve – not widely recycled.
MAX
150mm
STEP 9.
Locate MDF shelf level (E) into position, tapping lightly to ensure they
sit in recessed beam edges.
1. 2. 3.