Tradgardsteknik JF-400 User manual

JF-400
Glastvätt

User’s Manual
Important Safety Precautions
Rea all instructions before operating the evice
WARNING
1. Fasten the safety rope an tie to in oor fixture before operating the evice.
2. Check if the safety rope is broken or the knot is loose before operating the evice.
3. Set anger-warning area ownstairs for no-balcony win ow an oor.
4. Battery shall be full-charge (green lamp ON) before using.
5. Do not use it in rainy or moist ay.
6. Turn power on before put evice onto glass.
7. Make sure appliance can stick an stan on glass surface while put onto glass.
8. Before turn power off, please hol evice.
9. Do not use it on frameless glass.
10. Make sure put cleaning ring onto cleaning wheel correctly for no leakage.
11. Do not spray or pour water onto the appliance.
12. Prohibit chil ren from using this evice.
13. Remove anything on the glass. Do not use on cracke glass. Reflective or
coating glass might be slightly scratche ue to irt on the glass whileoperating.
14. Keep hair, loose clothing, fingers, an all parts of bo y away from the openings
an moving parts.
15. Do not use in areas with existe flammable or combustible liqui s, gas.
Product introduction
JF-400 is a glass-cleaning robot, with a vacuum motor insi e that can suckair an
stan on the glass surface. An embe e UPS (Un-interrupte PowerSystem) can prevent
the robot falling from the win ow even when no electricalpower.
JF-400 has two special- esign cleaning wheels that can freely traverse on thewin ow
surface an even on the wall. The easy replaceable lint free cloth is use onboth of the
cleaning wheels. Micro-fiber base cloth is use for goo glass cleaning.
JF-400 has AI-Technology that can calculate path, auto- etect fringe of win ow,auto-
clean entire win ow. Also has manual mo e for user operation.

Product and accessories
Device x 1
Remote controller x 1
A apter (100~240VAC, 50~60Hz) x 1
AC power cor x 1
DC power extension cable (4 meter) x 1
Cleaning cloth x 12
Cleaning ring x 2
User manual x 1
Product features
For any kin thickness glass
AI Technology
Cleaning spee : 4 minutes/meter^2.
3 kin s of automatic operation mo es for cleaning entire win ow
Auto-finish.
Embe e UPS (Un-interrupte Power System)
Anti- ropping control algorithm
Auto etect e ges of win ow
Micro-fiber cloth
High strength safety rope (150Kgf)
Remote control
Table cleaning mo e
Power consumption：80W
Input voltage: AC100~240V, 50~60Hz

Getting to know the device
JF-400 shall always connect power cable for normal using.
How to put evice onto glass to start using
(1) Turn on power-switch, an then make sure the fan is running.
(2) Put evice onto glass.
(3) Check if evice can stick to the glass before releasing it.

How to take evice own from glass
(1) While evice is running, please hol safety rope with one han an take evice own
from glass with the other han .
(2) Turn off power-switch in safe area.
Safety rope an buckle
(1) Before using, check if the safety rope is broken or the knot is loose.
(2) Fasten the safety rope an tie to in oor fixture before operating.
UPS (Un-interrupte Power System) function
(1) The UPS function will be enable automatically when no electric powersupplie . The
backup time of this UPS is 30 minutes.
(2) If no electric power is supplie , the evice will stop automatically, alert an flash re
lamp. User shall take evice own from the glass as soon as possible.
(3) User can pull evice back by pulling safety rope. Slightly pull the safety rope atan
angle close to the glass to prevent ropping.
Please make sure the battery was full-charge (green lamp ON) before using.
(1) First, turn off the power-switch on the evice. Plug in the power. Orange lamp ON
meansharging.
(3) Green lamp ON means the battery was full-charge .
Table cleaning mo e
Put evice on the table an select auto-cleaning mo e, the evice will run intable-cleaning
mo e.
Notice
(1) Do not use it on frameless glass.
(2) Make sure put cleaning ring onto cleaning wheel correctly for no leakage.
(3) Do not use it in rainy or moist ay.
(4) Set anger-warning area ownstairs for no-balcony win ow an oor.
How to clean the glass
Step I: Use clean-an - ry cleaning cloth to clean ust an san on the glass.
Step II: Change again the cleaning cloth. Keep upper wheel’s cleaning cloth asclean-an -
ry. Spray a little etergent (1~2 spray) on lower wheel’s cleaningcloth, but not
make cloth wet (if too wet, machine can’t move well). Thenclean the glass again.

Remote controller
The evice can be remote controlle from the front an backsi e.
Auto Up then DownAuto Left then DownAuto Right then Down
※ Please remove the insulation spacer in the bottom of back of remote controller
before using. If you have to replace the battery, just pull own the battery cover.

Power adapter/D extension cable
Using the cleaning ring and the cleaning cloth
1. Cover cleaning ring with cleaning cloth.
2. Put cleaning ring onto cleaning wheel correctly (luck 6 claws) for no leakage.

Frequently asked questions (FAQ)
Q1: If JF-400 can’t startup an alert at the beginning of self-test.
Ans: It means that the friction factor is not properly use . Pease check:
(1) Whether the cleaning cloth is too irty.
(2) Glass stickers, win ow film on the glass will also affect the friction factor.
(3) If clean win ow many times, the glass surface will become very slippery.
(4) The glass surface will become slippery if clean several times in low humi ity
environment such as in air-con itione room.
Q2: JF-400 slips an cannot etect the upper frame of win ow in “Auto Up then
Down”( ) mo e.
Ans: Press key an switch to or auto mo e.
Q3: JF-400 cannot finish whole win ow an stop at mi le area.
Ans: Press or auto mo e to continue cleaning.
Q4: JF-400 slips an cannot get higher to the win ow frame.
Ans: (1) Friction factor is too low that might be cause by glass stickers, win ow film
on the glass.
(2) Cleaning cloth might be too wet.
(3) If clean win ow many times, the glass surface will become very slippery.
(4) The glass surface will become slippery if clean several times in low humi ity
environment such as in air-con itione room.
Q5: JF-400 oes not move smoothly or move irregularly.
Ans: (1) Cleaning cloth is too irty. Please change a clean-cleaning cloth.
(2) Glass surface has ifferent friction factor areas ue to stickers, win ow film,
an so on. Please use JF-400 in single area.
(3) The screw of cleaning wheel might be get loose, just tighten it.
Q6: After cleaning, remaine circle mark on the glass surface.
Ans: Cleaning cloth is too irty. Please change a clean-cleaning cloth an clean
again.

Q7: What to o if JF-400 stoppe at higher area while no electric power supplie ,
JF-400 alarm an re lamp is flashing?
Ans: (1) User can pull JF-400 back with safety rope. Slightly pull the safety rope at
an angle close to the glass to prevent ropping.
(2) Switch the power-switch to “off”
(3) Check out whether electric poor-contact, cable broken or not.
Q8: What to o if JF-400 abnormally stoppe an re lamp is flashing, withoutalarm?
Ans:(1) User can move JF-400 to safe area by remote control, or pull JF-400 backwith
safety rope. Slightly pull the safety rope at an angle close to the glass toprevent
ropping.
(2) Switch the power-switch to “off”
(3) Check whether there is air-leakage cause by gap, uneven win ow frame.
Q9: When turn on power switch, the FAN o not rotating, an no alarm.
Safety information about power adapter/battery
Use only the power a apter supplie with this evice. Use of other type of powera apter
will result in malfunction an /or anger.
Please use the proper electric outlet an make sure no heavy objects are place on the
power a apter or power cor .
Allow a equate ventilation aroun the a apter when using it to operate the evice. Do not
cover the power a apter with objects that will re uce cooling.
Do not use the a apter in a high moisture environment. Never han le the a apterwith wet
han s.
Connect the a apter to a proper power source. The voltage requirements arefoun on the
apter.

Do not use broken a apter, power cor or plug.
Do not attempt to service the a apter. There are no service parts insi e. Replacethe whole
unit if it is amage or expose to high moisture. Consult your JF-400 ealer for help an
maintenance.
The battery use in this evice may present a risk of fire or chemical burn ifmistreate . Do
not isassemble, short contacts, heat above 60℃(140℉), orincinerate.
If you have to ispose of this ol equipment, please take it to the local recyclingcenter for
recycling electrical an electronic parts.
General safety information
Retain the safety an operating instructions for future reference.
Follow all operating an use instructions.
Do not expose your evice to rain or excess humi ity, an keep it away from
liqui s (such as beverages, faucets, an so on).
Avoi exposing your evice to irect sunlight or intense light source, an keep it
away from heat source (such as ra iators, space heaters, stoves, an so on).
Do not place the evice in the vicinity of strong magnetic fiel s.
Keep the evice an accessories away from chil ren.
Pro uct operating temperature: 0℃~40℃(32℉~104℉)。
Pro uct storage temperature: -10℃~50℃(14℉~122℉)。
Limited warranty
If there are efects in your JF-400 glass-cleaning robot ue to faulty
materials,workmanship or function within warranty perio from the ate of purchase
or elivery, please contact the local retailers or local authorize ealers for repair
orreplacement.

Non-warranty
Normal wear an tear (e.g. cleaning cloth, safety rope, etc).
Re uction in battery ischarge time ue to battery age or use.
Damage cause by assembling or installing that not in accor ance with the
instructions of JF-400
Damage cause by using the JF-400 glass-cleaning robot for any other
purposes than normal omestic househol .
Damage cause by using parts an accessories which are not specifie byJF-400
Damage cause by acci ent, abuse or misuse.
Trä går steknik AB
Helsingborgsvägen 578
262 96 ÄNGELHOLM
Telefon: [phone]
Telefax: 0431-222 70
info@tra gar steknik.se
www.tra gar steknik.se