TRAK RACER TR-TR8-M User manual

TR-TR8-M
Assembly Instructions
Important: Please ensure all screws have been installed correctly
and tightened for safety. TRAKRACER accept no responsibility for
damages caused to personal affects including monitor and other
accessories.
Step 1
Step 2
Step 3
Step 4
Step 5

Step 6
Step 7
Installation Guide
1. Before assembling the TR-TR8-M please ensure all
parts are included and there are no defects.
2. It is advised that assembly takes place on a soft surface.
For example, carpet.
3. TRAKRACER recommends the use of protective gloves
during assembly.
Important
1. Avoid direct sunlight, smoke and moisture.
2. To clean use a soft dry cloth. If the chair becomes too dirty
please use a damp cloth with 2% neutral cleaning agent.
3. TM-B3-27-3 Floor Monitor Stand For 22”- 35” monitors &
televisions
TM-B3-27 Floor Monitor Stand For single monitor 22''- 65''
4. TM-B3-37-3 Floor Monitor Stand For 36” - 45” monitors &
televisions
TM-B3-37 Floor Monitor Stand For single monitor 22''- 65''
5. Maximum Hole Spacing 200MM*200MM.
* IF holes spacing more than 200mm*200mm please buy
TRAK RACER TM-B-80 Accessories.
* IF use for Singl Monitor 65''-90'' please buy
TRAK RACER TM-B-80 Accessories.
© Copyright TRAKRACER 2019
HARDWARE PACKAGE
#1 M4*16 12PCS
#2 M8*60 4PCS
#3 M8*70 6PCS
#4 M8 6PCS
#5 M6*15 3PCS
#6 M8*16 12PCS
Please assemble all screws correctly and make sure all of them
tight enough.
Height adjustment range 0mm - 320mm
Safety hole: please insert screw when adjust angle, in case hurt
fingers or tv falls down. When finish adjusting, take out the
screw. TV incline angel adjustment range: -10°-15°
Angel between tvs adjustment range: 90°- 180°