TRAK RACER TR8 User manual

TR8
Assembly Instructions
Important: Please ensure all screws have been installed correctly
and tightened for safety. TRAKRACER accept no responsibility for
damages caused to personal affects including monitor and other
accessories.
Step 1
Step 2
Step 3
Step 4
Step 5

Step 6
Step 7
Step 8 – If mounting the Monitor Stand
Step 9
HARDWARE PACKAGE
#1 M8*20 4PCS
#2 M8*15 18PCS
#3 M8*20 4PCS
#4 M8*15 6PCS
#5 M8*16 10PCS
#6 M8 6PCS
#7 M8*60 2PCS
#8 M4*16 8PCS
Installation Guide
1. Before assembling the TR8 please ensure all parts are
included and there are no defects.
2. It is advised that assembly takes place on a soft surface.
For example, carpet.
3. TRAKRACER recommends the use of protective gloves
during assembly.
Important
1. Please use this product as a game chair only.
2. The simulator is not intended to be used as a stepping device.
3. Please don’t stand on the simulator as it may tip over.
4. The simulator is intended for use by one person per time.
5. Avoid direct sunlight, smoke and moisture.
6. To clean use a soft dry cloth. If the chair becomes too dirty
please use a damp cloth with 2% neutral cleaning agent.
© Copyright TRAKRACER 2019
If your monitors mounting points are 300mm x 300mm or
400mm x 400mm you will need the optional TR-80 VESA
bracket.
Mount and fix the lower half of the single monitor stand to the
TR8 frame. Secure by tightening the 4 screws. Mount the upper
half of the monitor stand onto the lower half and once you have
in position, tighten up the small grub screw to lock the upper
half of the stand in place.
Important. TRAKRACER accept no responsibility for damage to
televisions/monitors caused during and after assembly.