TransDeco TD585DB User manual

If you have missing parts or questions please email
[email protected] or call 909-606-3833
Mon-Fri 9 AM to 5 PM pacific time. Please have your product model
number available.

Install casters to side frames as shown.
Install the bottom shelf support beams.
Part #2 is on the back side of the unit.

Install the middle shelf support beams(Part #3) as shown.
Do not fasten the screws completely at this point for easy alignment later.
Install the top shelf support beams Part #4 & 5 as shown and check the bigger
pre-drilled holes for the glass are on the top of the beam.
Part # 4 is on the back side of the unit.

-Install the right side frame as shown.
-Do not fasten any one screw completely until all the beams installed and aligned.
-If there is any difficulty to align a screw hole please lossen the screws at the other end of
the beam then align the beam and fastern the screw again.
-Check the alignment of all the beams and tighten all screws.
-Install center support beams(Part # 6) as shown.

-Install the wire management panel as shown.
Apply Self-adhesive vinyl surface pads (Part # D)
on the beams as shown.