Travis Industries 99300650 User manual

Wall Thermostat
SKU 99300650
Page 1 of 3 2/2/11 - 17601040 © Travis Industries, Inc.
Compatibility
•All Travis Gas Stoves
•33 DVI Insert
•31 DVI Insert
•564 SS and DF
•864 TRV, ST, and HO
•All Travis Pellet Stoves or Inserts
Packing List
•Thermostat
•Thermostat Wire (20’)
•(2) Screws (for attaching thermostat)
Installation Warnings
! Shut off power to the appliance and allow it to cool prior to installation.
! This kit must be installed by a qualified technician.
! Do not connect 110 VAC to the gas control valve or on/off switch on gas heaters or the thermostat
posts on pellet heaters.
Follow the instructions on the following pages for the type of model being addressed.
Wire Connection - Pellet Heaters
Attach the thermostat wire to the circuit board.
b
Swing the
panel
open.
d
a
Phillips
Screwdriver
Open the hopper lid and remove the
screw holding the right panel in place.
Route the wires up to the circuit
board and attach the quick-connects
to the thermostat posts (orientation
does not matter).
Bundle up any excess wire with a
lock-tie to prevent it from contacting
any hot or moving parts
If necessary, attach the
pellet stove connector
wires to the ends of the
receiver wires.
c

Wall Thermostat
SKU 99300650
Page 2 of 3 2/2/11 - 17601040 © Travis Industries, Inc.
Wire Connection - Gas Heaters
Do not connect 110-120 VAC to the gas control valve or wiring system of this fireplace. The thermostat
and wiring must be installed by a qualified installer.
The included wire allows the installer to connect the thermostat to the on/off switch on the heater. Follow
the directions below to install the splitter in series or parallel connection.
WARNING: Make sure all wiring is secure and does not contact hot or moving components.
NOTE: The newer switch has two terminals and is pictured below. Older switches
have four terminals. Use the top and bottom terminal on either side of the
switch when connecting the wires (see the illustration to the right).
Parallel Connection On/Off Switch ON On/Off Switch OFF
Thermostat/External Switch ON Heater is ON Heater is ON
Thermostat/External Switch OFF Heater is ON Heater is OFF
To wire the heater in parallel, follow the directions below:
Series Connection On/Off Switch ON On/Off Switch OFF
Thermostat/External Switch ON Heater is ON Heater is OFF
Thermostat/External Switch OFF Heater is OFF Heater is OFF
To wire the heater in series, follow the directions below:

Wall Thermostat
SKU 99300650
Page 3 of 3 2/2/11 - 17601040 © Travis Industries, Inc.
Thermostat Placement and Installation
1 Determine a location for the thermostat that is within range of the 20' length of thermostat wire. It
should be centralized in the room and away from the heater. The wire may be routed externally on
the wall or behind the wall (preferred). Run the thermostat wire to this location. Use nylon ties, if
necessary to keep the wire from contacting any hot portions of the heater.
2 Follow the directions below to attach the thermostat and thermostat wires.
50 60 70 80 90
50 60 70 80 90
Robertshaw
Run the thermostat wires
through the wall (cut off excess
wire, leaving 6” of slack).
Pull the cover off the thermostat
Expose 1/2” of wire and
attach to these two posts.
Standard
Screwdriver
Attach the thermostat to
the wall through these
two holes.