Trax TRH0027 User manual

Radio frequency: 433.05~434.79MHz
Working temperature: -10 ℃ ~50 ℃
Transmitting power: 10 mW
Battery: 3V (CR2450) Battery life: >2 years
Radio range: 200 meters outdoor, 35 meters indoor
Technical specifications
TRH0027
Single-channel LCD
Remote Instruction
Version: T1
UP
STOP
DOWN
LED
Setting
button
(P2)
Setting
button
(P2)
TRH0027
Single Channel Remote
TRH0027
Back
Button Commands
To remove the back cover use a tool such as a SIM card pin,
mini screwdriver or paper clip. Press down on the center of
the hole on the back and simultaneously slide the cover in a
downward movement.
-4°F ~ 122°F 220 yards outdoor, 38 yards indoor
Warning
● Do not expose the remote to excessive moisture or water
● Do not strike or use excessive force on the remote
● If the remotes range is decreasing the battery may need to be replaced
● Only use CR2450 batteries in device
● If the voltage is less than 2.6V the remote will show a low voltage indicator
● Under uni-directional operating mode, pressing any button for more than
20s will stop radio signal transmission
● Under bi-directional operating mode, pressing any button for more than
5s will stop radio signal transmission
● Failure to follow these warnings may result in injury or render the remote
inoperable
● Always dispose of batteries properly

Flashes slowly
for 3 seconds
Flashes quickly
for 3 seconds
LED always on
Remote is locked
Remote is unlocked
Hold P2 button and
install the battery
Remote
without
battery
Bi-directional mode
Uni-directional mode
LED flashes twice
LED flashes once
Switching Between Uni-Directional and Bi-Directional Modes
Note: The factory default mode is Bi-directional
Locking/Unlocking Programming Functions on Remotes
Locking of remotes is used to prevent accidental changes to the pre-set positions of the motor such as open and closed positions as
well as preferred stop positions. Once all programming is complete for the remote and motor is is recommended that the
programming function be locked to avoid unintentional changes. Please note that locking the remote only locks motor functions,
functions on the remote such as increasing channels can still be performed.
Press and hold the - button
for more than 15 seconds.
Press P2 button located
on the back once