Chamberlain MC100AML User manual

ORDERING OPTIONS
MC100AML
SPECIFICATIONS
Chamberlain
Frequency - Multiple
Buttons - 2
COMPATIBLE WITH
Battery:
CR2032
MC100AML
Art.
G
C945
E940M
C940 E943M
CG844 CM842
CG842 CM844
HE433
CM128
84335
94335
C940
84330 C943
E950M E945M
E940C
E943M
062730
70241 70241-O 70241-P 62733 062730
70241 70241-O 70241-P 62733 4335EBD
COMPATIBLE WITH (EXTENDED)
SLEUROTX
SL4BRM
4330EBD CAD603 062170
PTX4v1
TX2 HC101 HC107 HC106
HC105 HC108 HC104 HC102
PTX4 PTX4-P
Remote Programming Steps
ON NEXT PAGE
E950C

Remote Programming Steps
Whilst every eort has been made to ensure the accuracy of the information supplied herein, we assume no liability for any errors or omissions. Information
contained in this document is subject to change without prior notice.
Program New Remotes to Receiver
1. Start with your garage door closed. Ensure that the door is clear
of all obstructions.
2. Press and hold the bottom button on the remote control until
the blue LED on the remote stays solid (approximately 15
seconds), then release the button.
3. Press and hold the LEARN button on your garage door opener
for 2-3 seconds before releasing it
4. On the remote control, press and release the remote button
you would like to program. The blue LED will blink for up to 60
seconds. Once the LED changes to solid blue, press & release
the button on the remote that you are programming.
5. The remote will begin ashing once every three seconds. Once
the door begins moving press the remote button again. Your
remote is now programmed to the garage door opener.
6. Repeat process for additional remotes if necessary
Program New Remotes to ATA Receiver
1. Start with your garage door closed. Ensure that the door is clear
of all obstructions.
2. Press and hold the bottom button on the remote control until
the blue LED on the remote stays solid (approximately 15
seconds), then release the button.
3. Press and hold the CODE SET button on the opener until the
completion of the next step
4. On the remote, press and release the remote button that you
would like to program. The blue LED on the remote will blink for
up to 60 seconds. Once the remote LED changes to solid blue,
release CODE SET button on the opener and press & release the
remote button you are programming.
5. The remote will begin ashing once every three seconds. Once
the door begins moving press the remote button again. Your
remote is now programmed to the garage door.
6. Repeat process for additional remotes if necessary