Treasure garden Evo User manual

User Guide

www.treasuregarden.com

v.06.25.20

EVO Dual-Light Sound Pod

EVO

WARRANTY:

Treasure Garden warrants this product

(for residential use ONLY) to be free

from defects in original materials and

workmanship for a period of 1 year from

the date of purchase. If a defect in the

original material or workmanship appears

during the warranty period; Treasure

Garden will (at its discretion) repair or

replace the product without charge.

Simply contact your original authorized

Treasure Garden dealer with a description

of the defect. The dealer will verify the

defect and work closely with Treasure

Garden to obtain the necessary service.

In many cases, simple problems can

be solved with a replacement part that

can be shipped directly to the dealer for

professional installation / repair.

There are no serviceable parts within this

product, DO NOT OPEN. Tampering with

or altering the product will void warranty.

In the event that warranted factory service

is required, Treasure Garden will assume

the responsibility of the return freight

charges for the first year only.

Returned product that (upon receipt and

inspection) is deemed to be “not covered”

under our warranty, will be shipped / billed

at your expense.

This warranty gives you specific legal

rights, and you may have other rights

which vary from state to state.

RUST: Rust is a natural part of the aging

process of steel or iron based materials,

and is therefore NOT considered a defect.

NOTE: Failure caused by unreasonable or

abusive use, or failure caused by neglect

of reasonable and necessary care are not

covered by this warranty.

Additionally, acts of nature (including but

not limited to wind, hurricanes, tornadoes,

and storms) are not covered by this

warranty.

Thank you for purchasing Treasure Garden’s EVO Dual-Light Sound Pod.

Please remove all contents from the package, inspect and review checklist.

CHECKLIST

A - (1) EVO

B - (1) Power Supply*

A -

SAFETY PRECAUTIONS

Unlock Button

Top Unit Bluetooth®

Power Button and

Charging Indicator Light

Top Unit LED Light

Power Button

Charging Port

Back View

Speakers

B -

*Note: Use only the power

supply included with EVO.

See page 6 for Safety

Precautions.

• Position the EVO in a location that will protect it from direct sunlight and moisture.

• Do not overcharge the battery. Unplug the power supply when the indicator light turns

off. Over charging may cause the battery to become hot, rupture or ignite. If you see any

heat deformation or leakage, properly dispose of the device.

• If unit is exposed to light moisture, allow unit to air dry for a minimum of 24 hours before

reuse.

• Power supply must be used indoors only. It is neither designed nor tested for use

outdoors.

WARNING: The EVO Dual-Light Sound Pod is not waterproof. If the EVO is immersed in

water or exposed to heavy rain the unit will be damaged and void the 1 year warranty.

NOTE: We recommend fully charging EVO before you store for extended periods of time.

Power Supply:

• Never use a third party battery or power supply. Doing so may increase risk of fire or

explosion. Contact your local authorized dealer for a replacement power supply.

• During prolonged use, it is normal for the power supply to be warm to the touch. When

using power supply, avoid direct sunlight and exposure to moisture.

• To prevent damage to the electrical components, do not use the charging or USB port

in inclement weather (rain, snow).

Bottom Unit Bluetooth

Power Button and

Charging Indicator Light

Bottom Unit LED Light

Power Button

USB Port

Front View

LED Lights

Sub-woofer/

Base

Power Supply Information

Input voltage: 100-240Vac 50/60Hz 1.6A

Output: 9.2V 2.5A

5’ Cord

USB Information

USB 2.0 Output: 5V 1A

The Bluetooth® word mark and logos are registered trademarks owned

by Bluetooth SIG, Inc. and any use of such marks by Treasure Garden

is under license. Other trademarks and trade names are those of their

respective owners.

STEP 1CHARGING

• Remove protective cap from charging/USB port and connect the power supply to the

EVO charging port, then plug the other end into any 110V power source. The EVO is

fully charged when the red Bluetooth indicator lights turn off (approximately 3 hours).

Note:

• Charge EVO in dry area to keep from damaging.

• Top unit must be installed on bottom unit correctly to charge. Make sure buttons on top

unit and bottom unit align prior to connection power supply.

• We recommend fully charging EVO before you store for extended periods of time.

STEP 2PAIRING BLUETOOTH DEVICE

• To turn on Bluetooth, locate the Bluetooth power button on the top unit of the EVO. Press

and hold Bluetooth power button for 3 seconds until you hear a prompt sound. The

Bluetooth indicator light will blink white when in pairing mode.

• From your music device, turn on Bluetooth and switch your device to discovery mode.

Select “EVO” from your device options. You will hear a set tone and the Bluetooth light

will become solid white once the EVO and your music device are paired successfully.

• To turn on bass speaker, locate the Bluetooth power button on bottom unit. Press and

hold Bluetooth power button for 3 seconds until you hear a prompt sound. The Bluetooth

Note:

• Sound quality will lessen or music

will stop playing when music device

is approximately 30 feet away from

EVO.

Top Unit

Bluetooth Power

Button

Bottom Unit

Bluetooth Power

Button

STEP 8USB PORT

• To charge electronic devices, remove protective cap from charging/USB port. Insert

USB cable into USB port located on back of bottom unit. Reattach protective cap when

not in use.

Note:

• If using USB port and lights, battery life will reduce to 4 hours.

STEP 7TABLE LIGHT

• With the top unit removed, press down adapter rod until rod locks into place.

indicator light will blink white first,

followed by a set tone, and then

become solid white. Your music

device and EVO top and bottom unit

are now paired successfully.

• Use controls on music device to

select songs from playlists and

adjust volume.

STEP 3UNPAIRING BLUETOOTH DEVICE

• Only 1 music device can be connected at a time.

• To pair another device, first unpair the current device by disconnecting Bluetooth on the

device, or pressing and holding the Bluetooth power button on top unit for 2 seconds.

You will hear a tone when the current music device unpairs and the Bluetooth light will

begin blinking white again.

Note:

• If you press Bluetooth power button once, the music device will pause. Press once again

and music will resume.

• If you hold Bluetooth power button for 4 seconds, the device will shut off.

STEP 4TURNING DEVICE OFF

• To turn off EVO, press and hold Bluetooth power button on top unit for 4 seconds. You

will hear a descending tone and Bluetooth Indicator lights will turn off. Both top and

bottom units will be disconnected.

Note:

• EVO will turn off automatically when Bluetooth is in pairing mode, or inactive for more

than 15 minutes.

• When your music device is disconnected, you will hear a prompt sound from EVO.

STEP 5LED LIGHTS

• To turn on and turn off LED lights, press the LED light power button located on top and

bottom units.

Top Unit

LED Light

Power Button

Bottom Unit

LED Light

Power Button

STEP 6ATTACHING EVO TO UMBRELLA

• The top unit of the EVO can be attached to umbrella center poles up to 2” and cantilever

umbrella light adapters.

• Open EVO by holding the device firmly with one hand and then press “unlock” button

with the other hand to release the clamp lock.

• Open up the EVO top unit, remove from Bottom unit, and clasp around the mid pole or

light adapter. Snap to close.

Note:

• When reattaching top unit to

bottom, make sure the buttons

on the top and bottom unit

align. Note the grooves on top

unit only line up one way.

• Doing so will cause damage to

electrical components.

STEP 3UNPAIRING BLUETOOTH DEVICE

• Only 1 music device can be connected at a time.

• To pair another device, first unpair the current device by disconnecting Bluetooth on the

device, or pressing and holding the Bluetooth power button on top unit for 2 seconds.

You will hear a tone when the current music device unpairs and the Bluetooth light will

begin blinking white again.

Note:

• If you press Bluetooth power button once, the music device will pause. Press once again

and music will resume.

• If you hold Bluetooth power button for 4 seconds, the device will shut off.

STEP 4TURNING DEVICE OFF

• To turn off EVO, press and hold Bluetooth power button on top unit for 4 seconds. You

will hear a descending tone and Bluetooth Indicator lights will turn off. Both top and

bottom units will be disconnected.

Note:

• EVO will turn off automatically when Bluetooth is in pairing mode, or inactive for more

than 15 minutes.

• When your music device is disconnected, you will hear a prompt sound from EVO.

STEP 5LED LIGHTS

• To turn on and turn off LED lights, press the LED light power button located on top and

bottom units.

Top Unit

LED Light

Power Button

Bottom Unit

LED Light

Power Button

STEP 6ATTACHING EVO TO UMBRELLA

• The top unit of the EVO can be attached to umbrella center poles up to 2” and cantilever

umbrella light adapters.

• Open EVO by holding the device firmly with one hand and then press “unlock” button

with the other hand to release the clamp lock.

• Open up the EVO top unit, remove from Bottom unit, and clasp around the mid pole or

light adapter. Snap to close.

Note:

• When reattaching top unit to

bottom, make sure the buttons

on the top and bottom unit

align. Note the grooves on top

unit only line up one way.

• Doing so will cause damage to

electrical components.