Trendwood 4522/4523 Laguna User manual

4522/4523 Laguna
4672/4673 Summit
LAGUNA/SUMMIT
TWIN/FULL BUNK
7030-00448
PARTS LIST:
A) 32 - 4" Decorative Head Lag Bolts
B) 1 - 4MM Allen Wrench
C) 2 - Top End Assemblies
D) 2 - Bottom End Assemblies
E) 4 - 5" x 75" Mattress Rails w/Support Cleats
F) 4 - 3 1/4" x 75" Guard Rails
G) 4 - 1/2" x 3" Wooden Dowels
H) 3 - 3 1/2" x 38 1/2" Mattress Supports
I) 3 - 3 1/2" x 53 1/2" Mattress Supports
J) 16 - 1 1/4" Wood Screws
K) 1 - 4MM Driver for Power Drill
L) 4 - Tack glides
TOOLS REQUIRED:
1) Phillips Head Screwdriver
NOTE: Tool recommended: Electric driver for 4MM driver
ASSEMBLY INSTRUCTIONS:
NOTE:
Make sure you have all parts before beginning assembly. If you need a part, contact the dealer where you
purchased your bed. On hardwood floors use the tack glides on the bottom bunk ends to provent scratching.
1) Attach two mattress rails(E) to two bottom end assemblies(D) with 8 lag bolts and tighten.
2) Attach two mattress rails(E) and two guard rails(F) to top end assembly with 24 lag bolts and tighten.
3) Place four wooden dowels in the four holes in top edge of bottom bunk assembly.
4) Place the top bunk assembly on the bottom bunk assembly, ensuring that the dowels are inserted in holes in the top bunk assembly.
5) Place 3 short mattress supports on mattress rail support cleats on top bed assembly, with one support in the center, and a
support pushed tightly against each end assembly. Repeat with 3 long mattress supports on bottom bed assembly.
6) Secure mattress supports with 16 wood screws, placing 2 screws in each end of the lower outboard mattress supports.
7) Add bunk boards or slat kits and the proper thickness innerspring bunk mattresses. See dealer for details.
BE SURE THAT LAG BOLTS ARE
STARTED INTO THE HOLES
ON THE FRAME RAILS DURING
ASSEMBLY.
START LAG BOLTS INTO ALL RAILS
BEFORE TIGHTENING.
MAKE SURE THAT THE 4MM DRIVER
IS FULLY SEATED INTO BOLTS
BEFORE TIGHTENING
All manuals and user guides at all-guides.com
all-guides.com

Installation of individual slats for use with Slat Roll (Slat roll sold separately) See your retailer for purchase of Slat Roll
SCREW
SCREW
SCREW
SCREW SCREW SCREW SCREW
SCREW
SCREW
SCREW
INDIVIDUAL SLATS INDIVIDUAL SLATS INDIVIDUAL SLATS
Installation of individual slats for use with Bunkie Board (Bunkie Board sold separately) See your retailer for purchase of Bunkie Board
SCREWSSCREWSSCREWSSCREWSSCREWSSCREWS
INDIVIDUAL SLATS INDIVIDUAL SLATS INDIVIDUAL SLATS
When used with a slat roll, the three
individual slats should be placed evenly in the gaps and underneath the strapping before fastening.
Individual Slat
Individual Slat
Individual Slat
All manuals and user guides at all-guides.com