TRI-ARC U-DESIGN User manual

2
3
1
50° LADDER
*INCLUDES LEG KIT
Crossover Bridge & Turn Platform
Assembly Instructions
*ASSEMBLY REQUIRES AT LEAST 4
PERSONS CAPABLE OF LIFTING 50 LB EACH.
Inspect all pieces for damage upon delivery.
Inspect delivery for missing parts. Report
damages and missing parts to your U-Design
vendor.
1.
75° LADDER
*INCLUDES LEG KIT
90° LADDER
2. If installing a Turn Platform, install Leg Kit and
Rail Kits per Leg Kit Assembly Instructions and
Rail Kit Assembly Instructions.
CROSSOVER BRIDGE
TURN PLATFORM
*INCLUDES LEG KIT & (2) RAIL KITS

2.
*ASSEMBLY REQUIRES AT LEAST 4
PERSONS CAPABLE OF LIFTING 50 LB EACH.
DO NOT USE THIS PRODUCT UNTIL ALL ASSEMBLY STEPS HAVE BEEN COMPLETED FOR
ALL UNITS IN THE CROSSOVER SYSTEM AND THE GUIDELINES FOR CROSSOVER SYSTEM
ASSEMBLY ARE FOLLOWED. SEVERE INJURY WILL OCCUR IF ALL STEPS ARE NOT
CAREFULLY FOLLOWED.
3. Fasten the Crossover Bridge and Turn Platform to the adjacent part as
shown using (6) 3/8" bolts and nuts and (12) washers (included) for each
adjacent part. Do not face threaded end of the bolt toward the traveled
side of the ladder or platform. Do not fully tighten fasteners until all
steps are completed.
LEG KIT REQUIRED IF ANY SPAN EXCEEDS 90"
If any connected parts create a span greater than 90", a Leg Kit is
required. Install a Leg Kit to reduce span to 90" or less as per leg kit
assembly Instructions
ENSURE ALL FASTERS ARE SECURELY TIGHTENED
BEFORE USE.