Tripp Lite U234-005-R User manual

User’s Manual
USB 2.0
PCI Card - 5 Port
Model #: U234-005-R
NOTE: Follow these installation and operating procedures to ensure correct performance and to prevent damage to this
unit or to its connected devices.
Copyright © 2002 Tripp Lite. All rights reserved.
All trademarks are the property of their respective owners. Technical specifications are subject to change without notice.
Tripp Lite World Headquarters
1111 W. 35th Street
Chicago, IL 60609 USA
[phone]
www.tripplite.com

This fully functional USB 2.0 Host PCI Card supports High-
Speed, Full-Speed, & Low-Speed operation and follows the
Enhanced Host Controller Interface (EHCI) specification.
Overview
Package Content
• Hardware: USB 2.0 PCI card
• Software: Driver on CD
• User's Manual

Product Features
• USB specification revision 2.0 compliant
• Data transfer rate up to 480Mbps
• Support up to 127 USB devices
• Supports all USB devices - backward compatible with USB
1.1 devices
• OHCI specification for USB 1.1 compliant
• All 5 ports (4 external and 1 internal) support High-speed
(480Mbps), Full-speed (12Mbps) or Low-speed (1.5Mbps)
• 32-bit 33MHz host interface, PCI specification revision 2.2
compliant
• PCI-Bus power management interface specification revision
2.1 compliant
• Supports hot swap and wake-up
4 External USB ports Internal USB port

PCI Card Requirements:
• IBM®PC Pentium II 266MHz CPU or higher or
compatible system
• Available PCI slot
• CD ROM drive for software
• Windows®98/98SE or higher
1) Turn off PC, unplug power cord, disconnect all
peripherals and open the PC case.
2) Find the PCI slot on the motherboard, remove any
add-on card blocking easy access to the PCI slot.
3) Remove the USB 2.0 PCI card from the anti-static bag
and push it into the first empty PCI slot.
Note: There is only one way that your USB 2.0 PCI card can fit into the
slot correctly.
4) Re-install any add-on card that was removed, close the
PC case, re-connect all peripherals and plug the power
cord back in.
System
Requirements
Hardware
Installation

Driver
Installation
Windows 98/ME shown as an example,
Windows 2000 similar.
Driver installation for
Windows systems only.
MAKE SURE YOUR USB
PERIPHERALS ARE NOT
CONNECTED TO THE NEW CARD.
1) Turn your system on. When Windows boots up, it will
automatically detect the presence of the new PCI card.
The New Hardware Wizard will appear. Click "Next" to
continue.

Driver
Installation (Cont.)
2) When the following window appears, select "Search for…"
then click "Next".
3) When the following window appears, insert the driver CD
supplied with your USB 2.0 PCI card into the computer's
CD drive. Select CD-ROM Drive and click "Next" to con-
tinue.

Driver
Installation (Cont.)
4) When the following window appears, select "The
Updated…" and click "Next".
5) When the following window appears, click "Next". Files
are now being copied to your hard drive.

Driver
Installation (Cont.)
6) The following window will appear.
When the following window appears, click "Finish"

Driver
Installation (Cont.)
7) When the following window appears, follow same process of
steps 1-6.
8) When the following window appears, click "Next".
9) When the window in step 2 appears, select "Search for…"
then click "Next".

10) When the following window appears, Select CD-ROM
Drive and click "Next".
11) When the following window appears, click "Next".
Driver
Installation (Cont.)