Tronix RAL7024 User manual

View instructions and
technical data also on
our website
Read these instructions & save for future use
Article number
Brand
230-001
Tronix Lighting
Type Area lighting
Content of this product 1x Wallpack 20W
Technical datasheet Digitally available
on our webshop
Wallpack | 20W | 4000K |
gray RAL7024

230-001
Description
This LED Slim Wall Pack lamp has a slim design and is designed for long life
without maintenance.
Features
• Very low light nuisance compared to traditional Wall Packs;
• Excellent rainwater protection thanks to IP66 rating;
• Lightweight design;
•RAL7024 finish making it compatible with Streetlights RAL7024;
•Can be combined with Photocell day/night sensor (see related
products).
Installation
1. Turn off the power, remove the product and associated parts from their packaging and check the wiring present
before installation;
2. Open the Wallpack and underlying protection to access the wiring and driver;
3. Remove the inner plate by loosening the screws. This gives you access to the drill holes on the back of the Wallpack;
4. Press the back plate against the wall, pull the cable through the indicated hole and attach the plate;
5. Replace the interior and connect it. Check the wiring and then close the Wallpack using the cover;
6. Check the complete installation after the Wallpack is attached. Should it be in order, the mains power can be reacti-
vated.

Before getting started with this product, it is advisable to check the order completeness and any damage. If this is the
case, please contact Tronix Lighting.
Off
On

230-001
Safety
Safety is a top priority at Tronix Lighting. Therefore, we heartily recommend that you follow the following steps closely:
• Keep this manual carefully for future reference;
•Choose a qualified electrician while installing, maintaining or inspecting this product;
•Never look directly into a light source to avoid possible damage to the eye;
• Always ensure that the relevant power group is on non-active when the product is connected;
•Use only recommended combinations (LED drivers, controllers or dimmers) to avoid injury or damage to the product.
The CE mark indicates that this product complies with EU regulations on safety, health and environmental
protection;
The WEEE symbol stands for "Waste Electrical and Electronic Equipment Regulation," a directive on the
collection, recycling and recovery of electronic waste;
The Class I symbol indicates that this product is protected by means of the additional ground cable. This
cable is identified by the yellow/green jacket and is attached to this product.
Terms and symbols (as relevant to product)
• This product has an IP66 rating. This means the housing is touch-safe, fully protected from dust and water
resistant (100 l/min) regardless of angle.
Technical problems and repair
Should a product not work properly after installation, or if the product exhibits
problems over time, it is advisable to check the following elements:
• Check the wiring and installation of your product;
• Check for the presence of disruptive elements such as dust, water or other
electronics;
•Should it be possible, try disconnecting the product and testing it in another
location to rule out a problem at the location;
Should you be dealing with a WIFI-based product, check and reset your router's
settings.
Should the product still not work after testing, it is recommended to send it in for
inspection and/or repair. To do so, please contact Tronix Lighting using nearby
details and proof of purchase (packing slip).
Supplier:
Tronix Lighting B.V
Vluchtoord 41
5406 XP Uden, Netherlands
[phone]
[email protected]