Troy-Bilt 31AS6BN2711 Guide

IMPORTANT: READ OPERATOR'S MANUAL THOROUGHLY AND
FOLLOW THE SAFE OPERATION PRACTICES BEFORE OPERATING .
Read and understand all instruction, warning and danger labels.
Need Help? Call 1-888-TO-HELP-U (1-888-864-3578)
Chute
Chute Control Rod
Wing Knobs
778-10555A© 2005 31AS6BN2711
Tighten wing knobs.
Pivot handle upward.
Remove flat washer and hairpin clip.
Insert chute control rod into bracket as
shown. Secure with washer and clip.
Place chute over base and close flange keepers (3).
Keepers will click into place when properly secured.

IMPORTANT: READ OPERATOR'S MANUAL THOROUGHLY AND
FOLLOW THE SAFE OPERATION PRACTICES BEFORE OPERATING .
Read and understand all instruction, warning and danger labels.
Call 1-888-TO-HELP-U
Need Help?
(1-888-864-3578)
5
6
7
8
9
Gas Cap
Primer
Throttle
Key
Choke
10
Start
Button
Switch Outlet
Connect power cord to switch outlet on engine.
Fill tank with gas to within 1/2 inch of top of tank.
Check oil level and fill if necessary.
Push key into ignition slot. Be sure
ignition key snaps into place.
Rotate choke control to full choke position. Push primer three times.
Move throttle control to fast (rabbit) position.
Press down on starter button for no more than
five seconds to start engine. Disconnect power
cord and move choke control to off after starting.
Do not turn key.
Oil