TuControls Safepod User manual

Supply Cable
The RCD circuit breaker
(1) must only be used
in an indoor, earthed,
three pin mains socket.
Ensure that the cable
from the RCD plug to
the Primary Safepod
module cannot be
trapped cut or damaged
and does not create a trip hazard.
Do not connect the power to the Safepod
module until the module is secured in a vertical
position and the cover is
closed.
The external
waterproof plugs and
sockets automatically
lock together with a
simple plastic clip (2).
An audible “Click” will be
heard. To disconnect this
clip insert a screwdriver
into the slot and pull the
connectors apart.
Safepod Module
Secure the Safepod Module to a rigid vertical
surface. Use at least two of the four corner
fixing holes. Use the module as a template to
mark the position for the wall plugs and screws
provided.
The cover can be removed for ease of fixing
(3). Ensure that the rubber seals are clean and
dry before replacing the cover. Do not connect
the power until the Safepod Module is secured
and the cover replaced. Do not operate with
the cover removed
at any time
Select a suitable
vertical surface
protected from
running water and
extreme weather.
Position out of reach
of children and pets
(4). Do not attempt to remove the internal
switch plate or the external connectors.
The external waterproof plugs and sockets
automatically lock together with a simple
plastic clip. An audible “Click” will be heard. To
disconnect this clip
insert a flat
screwdriver into the
slot and pull the
connectors apart.
Appliances using
a 3pin mains plug
can be connected by
plugging into the
independently
switched 3pin
sockets inside the
Safepod. Disconnect power before opening the
cover.
Dry the module to prevent water entering the
Safepod Module. Plug in the appliance and
ensure the cable is lying across the soft
membrane. Ensure cover latches closed with
audible “click”. Leads should hang down and
be secured whenever possible.
Keep cover closed and secured when power
is on. The red light shows when power is
connected to the Safepod.
Installation Instructions
1
2
3
4
Warning: SafePod has been designed to be simple to install and
safe to operate. However, electricity can be dangerous and if in
any doubt, call in an electrician to install your SafePod.
M

Additional Modules
A second module can be connect to the first by
removing the sealing bung in the right hand
side outlet socket of the primary module and
pushing the plug of the second module into the
socket. Listen for the audible “click”.
Disconnect power before making this
connection (5).
Inserting a flat blade screwdriver into the slot
inside the cover can separate the connector on
the right hand side of the Safepod module.
Disconnect the power before connecting or
disconnecting the plugs and sockets.
The second module must also be secured to a
rigid surface (6). A third module can be added
in a similar manner. Ensure that the power
consumption does not exceed 10 amps.
The socket in the timer module is only live
when the timer is on. The socket can be
switched off using the switch adjacent to the
socket. The
red light will
indicate
when power
is connected
to the
Safepod.
Extension
Cables
An extension
lead can be used to position a second or third
module in a
different
location from
the primary
Safepod
module. Leads
can be
connected
together (7 &
8) using the
sealed
waterproof
connectors to extend the range of the Safepod
modules. Ensure that the power is off and the
connectors are dry when making any
connection. Listen for the audible “click” to
ensure a waterproof connection.
Astralux Dynamics Ltd,
Red Barn Road, Brightlingsea, Essex CO7 0SW, United Kingdom
Tel: [phone] • Email: [e-mail] • Web:www.astralux.co.uk
5
6
7
8
This product must not be discarded with general household waste.
Private Households may return electrical and electronic equipment to
designated collection facilities for material recovery and recycling.
TuControls Limited
15/16 Jubilee End, Dale Hall Industrial Estate, Lawford, Essex. CO11 1UR. United Kingdom
Tel: [phone] E-mail: [e-mail] Web: www.tucontrols.com