Tumbl Trak Boundex User manual

Assembly Instructions
Boundex
Parts:
A. (4) Foam covered support bars
B. (4) Upright legs with D2 knobs
C. (1) Yellow Lycra bed
D. (2) Small top layers of Lycra with
bungee corners
E. (1) Blue Lycra skirt
F. (1) Not pictured: Drawstring carrying bag
Parts List
A.A.
B.
C. D.
E.
Any questions or problems, please call Tumbl Trak at [phone]
Thank you for investing in the
Tumbl Trak Boundex. After
opening the boxes, please check
the parts list to make sure all
pieces have arrived in good
condition. If you have any
questions during the
assembly process, please call
customer service at
1-800-331-4362.
General Lycra Care Tips
• Hand or machine wash in lukewarm water on
gentle cycle using mild detergent
• Do not use chlorine bleach on any fabric containing
Lycra
• Rinse thoroughly
• Drip dry. If machine dried, use low temperature
• Do not iron

STEP 1 – Lay the yellow Lycra bed out at and locate the four openings at
each corner.
STEP 3 – It is easiest to begin aaching the rst leg by laying it on the ground.
Make sure the D2 knobs are facing down. Aach the rst leg by inserng the
support bar end into the coinciding leg side.
STEP 3 (A) — To insert the other bar, li up the leg making sure the hole and D2
knob is aligned to successfully lock into place.
Step 1
Step 3
Step 3
Step 2
STEP 2 — Feed one foam covered support bar through each sleeve of the Lycra bed, forming the square for
the top of the Boundex. STEP 2 (A) — Make sure each bar is facing outward.
Step 2 A
Step 2
STEP 4— While sliding the upright legs into the support bars, make sure to pull
the knobs outward at rst unl the bar slides past the knob, then release and
adjust unl you hear an audible click, indicang the knob is in place.
Then, ghten the knobs securely.
Step 3 (A)
Step 4
Any questions or problems, please call Tumbl Trak at [phone]

STEP 7— Once the Boundex frame is completely set up, lay one of the small layers of Lycra on top on the
yellow bed and align the bungees at the four corners.
STEP 8— Pull string through opening of the two support bars.
STEP 8 (A)— Stretch the string outward to go around both D2 knobs.
Any questions or problems, please call Tumbl Trak at [phone]
STEP 5— Insert the remaining upright legs into the D2 knobs at each
corner of the Boundex.
Step 5
STEP 6— Once you get to the last corner, you will have to stretch the Lycra and pull the last two ends of the
support bars into the D2 knobs. Make sure all ends are ghtened.
Step 6
Step 7
Step 8 Step 8 (A)

STEP 10 — To add the Lycra skirt, place over
top and locate the 4 corners of skirt to align
with each end.
Step 10
STEP 11 — Stretch corners of Lycra skirt over the
knobs unl the legs are covered.
Step 11
STEP 12— The Lycra skirt will cover each side of the
Boundex.
Step 12
STEP 9 — Repeat this process at each corner with the bungees. Place the second layer of
Lycra with bungees across the rst layer and repeat process with aaching bungees at each
corner.
Any questions or problems, please call Tumbl Trak at [phone]