TurboTronic Z-ESPRESSO TT-CM25 User manual

Instructions Manual
Grind & Brew Coffee Machine
TT-CM25
www.zline-world.com
EN

Thank you for buying Z-ESPRESSO - Grind & Brew Coffee Machine by TurboTronic®.
TT-EV25 is a professional household coffee maker with electric grinder guarantees quality and
fresh results, so you can enjoy your favorite coffee at home or in the office.
Ground coffee should be brewed within a minute of grinding as the volatile aromatics begin to
dissipate almost immediately once ground. Therefore, the built-in grinder allows you to capture
freshness and essential oils from the coffee beans by grinding right before you brew. The machined
stainless-steel burrs deliver consistent ground particle sizes for a more balanced, full flavored cup.
220-240V~50Hz, 600W for Heating
220-240V~50Hz, 120W for Grinding
IMPORTANT SAFEGUARDS
HOUSEHOLD USE ONLY. READ ALL INSTRUCTIONS.
When using electrical appliance, basic safety precautions should always be followed,
including the following:
Read this user manual carefully, before you use the appliance, and keep it safely for future
reference.
WARNINGS
Avoid deadly electrical short circuit and fires
Read all the descriptions
The electrical appliance must be reliably connected to the power supply with
grounding device to ensure that the power supply is suitable for the machine.
Never immerse the machine, power cord and power plug in water or other liquids
Do not pull, clamp, or suspend the power cord at the corners. Do not place th e
power cord on a hot or wet surface.
In order to avoid dangerous damage, please do not place hot appliances on or
near the appliance. The appliance must be placed on a stable desktop.
Make sure the machine is off before plugging in the wall outlet
Unauthorized crossover cables or extension cords are prohibited. When using
the unit for the first time, it may emit a slight odor due to insulation and heaters,
and will disappear after a few minutes.
Keep the power cord away from the hot parts of the machine
When disconnecting the power, do not pull the power cord directly.
Turn off the power after using the machine

Do not remove the protective case of the machine for any reason.
Do not allow children or people with disabilities to operate the unit without strict
supervision, and do not operate the unit without guidance.
Never use the machine while barefoot and wet hands
Unplug the power cord before cleaning the machine, and unplug the power cord
without any operation.
This product does not apply to persons (including children) who are physically,
mentally or mentally deficient or lack the necessary experience and knowledge,
except under the supervision of the person responsible for their safety.
Please save the following instructions and proof of purchase to ensure your
legal rights.
KEY SPECIFICATION
Model No: TT-CM25
Rating: 220-240VAC~50/60Hz
Heating power: 600W
Motor power：120W
Water tank capacity：450ml (MAX）
Coffee capacity : 400ml（MAX）
KEY STRUCTURE INTRODUCTION
①Grinder Blade
②Filter
③S.S mug
④Filter holder
⑤Water tank cover
⑥Water tank
⑦Main body
⑧Grind & Brew button
⑨Coffee powder button
⑩ON/OFF button
1
2
3
4
5
6
7
8
9
10

INSTRUCTIONS FOR USE
Preparation before brewing tea
Preparation for the first use of the machine (machine cleaning)
WARNING: Make sure that the connected power supply is suitable for the machine, otherwise the
machine may be damaged.
1.Open the water tank lid
2.Add in certain volume
water, and don’t water
should not over the “MAX”
level marking on tank
3.Close the tank lid
4.Filter holder match the UN-
LOCK symbol and turn it
clockwise to lock it on
housing;
5.After you locked well, the
allow on filter holder handle
should perfect match LOCK
symbol
6. Put back the S.S mug on
tray
7. Make sure the voltage is match with
product’s rated voltage, then plug in
switch
Coffee powder brewing switch
8. Press “ON/OFF” button, machine under
standby mode, and then press “Coffee powder
button” to let machine start heating，let hot
water flow through the inside tube and also
washing the filter holder and final the mug; while
finished 1 cycle, machine buzzer will have 3
times B-B-B warning, then 1st cleaning step
finished, you can start to prepare your fresh
coffee; if needed, can repeat this 2-3 times to
make sure whole machine was well cleaned

GRIND & BREWING OPERATION
ATTENTION：
1. There is safety micro switch on this machine, user need to make sure on above STEP 5,
filter holder should be assembled well, otherwise machine will not start;
2. When machine was well assembled, after plug in the machine will have B sound reminder
to confirm it was well connected with electricity, and ON/OFF button will light on in the
mean time;
3. Always checked if the filter holder was assembled well and mind the gap between filter
holder and housing is perfect or not before each brewing
1.Open the water tank lid
2.Add in certain volume water,
and don’t water should not over
the “MAX” level marking on
tank
3.Close the tank lid
4. Make sure filter was
well placed in filter holder
5.Use the spoon to add in
certain coffee bean you
need (3-4 Spoon)
6. Well placed the grinder
blade inside filter holder
7. Filter holder match the UN-
LOCK symbol and turn it
clockwise to lock it on
housing;
8. After you locked well, the
allow on filter holder handle
should perfect match LOCK
symbol
9. Put back the S.S mug on
tray

COFFEE POWDER BREWING
ON/OFF button
Grind & Brew button
11. Press “ON/OFF” button, machine under standby
mode, and then press “Grind & Coffee button” to let
machine start heating; While grinding, the machine will
intermittent running, this is normal and better to ensure
the grinding result; After grinding finished, machine will
auto turn to brew mode and prepare your fresh coffee,
While finished 1 cycle, machine buzzer will have 3
times B-B-B warning, fresh coffee is ready in mug; you
can start to enjoy it.
1.Open the water tank lid
2.Add in certain volume water, and
don’t water should not over the
“MAX” level
3.Close the tank lid
4. Make sure filter was well placed
in filter holder
5.Use the spoon to add in
certain coffee powder you
need (2-4 Spoon)
6. Well placed the grinder
blade inside filter holder
10.Make sure the voltage is match with
product’s rated voltage, then plug in
7. Filter holder match the UN-
LOCK symbol and turn it clockwise
to lock it on housing;
8. After you locked well, the
allow on filter holder handle
should perfect match LOCK
symbol
9. Put back the S.S mug on
tray

CLEANING & MAINTAIN
1. After brewing the Coffee/tea, remove the entire brewing basket from the machine and dispose
the leftovers into the trash, after wash it in faucet or in the dishwasher.
2. Do not immerse the plug, power cord or tea maker in water.
3. The surface of the whole machine should be wiped with a damp soft cloth, not a hard brush.
4. Filter holder buckets and other moving parts can be soaked in warm water or mixed with a specific
proportion of special detergent for about five minutes. It is then rinsed with water and dried for assembly.
6. Descaling: Coffee machine must regularly descaling, otherwise it will affect the taste of coffee/tea or
even damage the machine.
①Cleaning frequency: Soft water, once every three months; Hard water, once a month.
②Descaling agent: It is only suitable for special tea liquid detergent. Do not use solid detergent.
11. Press “ON/OFF” button, machine under
standby mode, and then press “Grind &
Coffee button” to let machine start heating;
While finished 1 cycle, machine buzzer will
have 3 times B-B-B warning, fresh coffee is
ready in mug; you can start to enjoy it
1. Turn the filter holder
Anti-clockwise and
take off the filter
holder
2.Pour out the coffee
trash inside
3.Take off the grinder
blade/filter/filter holder, use
fresh water to clean each part
completely and separately
10.Make sure the voltage is match with
product’s rated voltage, then plug in
Brew button

COMMON FAULTS AND SOLUTIONS
Problems
Reason analysis and solutions
The coffee machine did
not work and there was
no reaction.
Check that the machine 's plug is plugged in properly
Maker sure the filter holder was locked in housing well
The process of making
coffee produces noise
and a lot of steam
The coffee machine needs descaling
Tea is not strong enough
or too strong
Check the water and coffee ratio ( 21g tea powder: 400ml tea )
The machine can be
turned on but can't make
coffee
Check that the brewing container is in place
Press the switch a few
seconds after the
machine issued three
"drip" alarm sound to
stop working
Maybe the machine is still in the temperature protection time
or check the water tank for fresh water
ATTENTION
1. To brew good coffee, please make sure to replace it with fresh drinking water.
2. Ensure that the tea residue is removed in time to avoid deterioration of the tea residue in the
brewing barrel.
3. When using this machine to brew tea, the concentration of tea is not limited, users can increase
or decrease the amount of water according to their own taste.
DISPOSAL OF OLD ELECTRICAL APPLIANCES
The European directive 2002/96/EC on Waste Electrical and Electronic Equipment
(WEEE), requires that old household electrical appliances must not be disposed of in the
normal unsorted municipal waste stream. Old appliances must be collected separately in
order to optimize the recovery and recycling of the materials they contain, and reduce the
impact on human health and the environment.
The crossed out “wheeled bin” symbol on the product reminds you of your obligation, that when you
dispose of the appliance, it must be separately collected.
Consumers should contact their local authority or retailer for information concerning the correct disposal
of their old appliance.

LIMITED WARRANTY
Limited Warranty applies to purchases made from authorized retailers of TurboTronic®.
TurboTronic®Warranty coverage applies to the original owner and to the original product only and is
not transferable.
TurboTronic®warrants that the unit shall be free from defects in material and workmanship. Limited
Warranty apply only when it is used under normal household conditions and maintained according to the
requirements outlined in the Owner’s Guide, subject to the following
conditions and exclusions:
What is covered by this warranty?
1. The original unit and/or non-wearable parts deemed defective, in TurboTronic®sole discretion, will
be repaired or replaced
2. TurboTronic®reserves the right to replace the unit with one of equal or greater value.
What is not covered by this warranty?
1. Normal wear and tear of wearable parts (such as blending vessels, lids, cups, blades, blender bases,
removable pots, racks, pans, etc.), which require regular maintenance and/or replacement to ensure the
proper functioning of your unit, are not covered by this warranty.
2. Any unit that has been tampered with or used for commercial purposes.
3. Damage caused by misuse, abuse, negligent handling, failure to perform required maintenance (e.g.,
failure to keep the well of the motor base clear of food spills and other debris), or damage due to
mishandling in transit.
4. Consequential and incidental damages.
5. Defects caused by repair persons not authorized by TurboTronic®. These defects include damages
caused in the process of shipping, altering, or repairing the TurboTronic®product (or any of its parts)
when the repair is performed by a repair person not authorized by TurboTronic®.
6. Products purchased, used, or operated outside Europe.
Illustrations may differ from actual product.
We are constantly striving to improve our products, therefore the specifications contained herein are
subject to change without notice.
TurboTronic®and Z-Line®are registered trademarks of Z-GLOBAL B.V.B.A®.
PRINTED IN PRC