Turingsense PIVOT User manual

Required Materials:
•Sensors
•iPad
•PIVOT app
•Cradle
•Body straps -OR- Shirt

Step 1 - Preparation:
•Put all 5 sensors in the cradle in numerical order
•Turn the sensors on by holding down the button for 2 seconds. The
light should turn green. If they do not, turn them off and turn them on
again until they do.

Step 2 - Setup:
•Connect to iPad settings app. The name should
begin with the Ex: H31, H32 and the password is
“hhh”
•Exit and open the Pivot app
•Press “Request Password”
•To begin setup tap the red X on the bottom left of the screen.

Step 3 - Connection:
•Select the appropriate configuration according to the number of
sensors being used. Tap “Next”
•There should be a light blue “Start” button at the bottom of the screen.
•Tap “Next”

Step 4 - Initialization:
•The lights on the sensors should be light blue now. If not, restart
setup process.
•With all five sensors in it, until the lights turn solid green.

Step 5 - Calibration:
•Wear the sensors and hub in order(as necessary):
•Sensor #1 should be placed in the pocket on the back of the
palm, with the usb port facing toward the fingers and the light
outward
•Sensor #2 goes on the wrist, usb port facing towards fingers,
light outwards

•Sensor #3 goes on the armband, usb port toward the elbow,
light outward
1
2

•Place sensor #5 on the shoulder of the chest strap, usb port
facing away from your body, with the light outward. This sensor
should be sideways.

•Attach sensor #6 to the racket using the double lock velcro and
rubber band provided, usb port facing towards the strings, light
facing up
•Tap “Start” once you have put on all the sensors, and stand upright
with hands at the side
•Lights should turn blue
•Stand still until calibration completes
•Lights should turn green when completed
•proceed to the main menu