unios Mirage Operator's manual

Edition 12.1.21 | Product design and technical data may be subject to changeEdition 12.1.21 | Product design and technical data may be subject to change
unios.com
Page 4/4
Disposal
Ensure correct disposal of this
product (waste electrical and
electronic equipment).
Ambient Conditions
Recommended to install in an
ambient temperature <35°C.
Minimum clearance for luminaire
Risk of Fire – Required clearance from structure members and building elements. Details below:
Recessed
Luminaire
Building
Structural
Member
Barrier required for loose fill insulation
or loose combustible materials
All measurements are based in millimetres.
Ceiling
Transformer
Building Element Above Fitting
Please ensure the driver is
fixed above any insulation
Corrosion Protection
It is important to note that care must be taken
during installation or maintenance to ensure that
the surface of the luminaire is not damaged. Any
damage, which is exposed to moisture will result
in corrosion occurring.
Please also note that any chemical applications on
the luminaire or chemical contact via installation will
cause corrosion of the surface of the luminaire and will
void the warranty.
Thermal
Insulation
Cleaning
Warning: Before cleaning, disconnect from
mains supply and allow luminaire to cool.
1 2
Power
13 ~ 36 Watts
Material
Aluminium
IP Rating
20
unios.com
Page 1/4
Mirage
MW110
MIRW0110
MW162
MIRW0162
Base
Codes
Install Person/s
1x
Sizing Variations
B
C
A
MIRW0110
MIRW0162
AProduct Code
110
162
B
128
190
C
100
150
Class III
Luminaire only
All measurements are in millimetres.
For comprehensive protection of a luminaire against electrical surges, surge protection shall be installed
on the mains supply where required to protect luminaires and drivers from transient voltage damage.
CAUTION – This product must be installed by a qualified installer
Please read instruction manual carefully before installing luminaire
Surge Protection
For warranty information visit unios.com/warranty
Please read these installation instructions carefully before installing this product. This product must be installed and
maintained by a suitably qualified person/s in compliance with the latest applicable regulations and relevant legislation.
Unios does not warrant any claim based on defects or damage caused by misuse, improper installation, improper
operation and/or modifications carried out by the purchaser or third parties. This product shall not be used as a
'working light' during construction. This will result in the warranty of the product to be void. For warranty duration,
please refer to the data sheet.
WALLWASHER
100
50
100
Do Not Cover Luminaire
Tested to and in
accordance with
AS/NZS 60598.2.2:2016

Edition 12.1.21 | Product design and technical data may be subject to change
Page 2/4 unios.com Page 3/4
X
Vertical
X= 1-12.5mm
Horizontal
X= 12.5-25mm
Spacing Recommendation
ON
OFF
Wiring
AC
240V
Power Source
SELV
L
DRIVER
LED
N
Dimming
This luminaire can be dimmed. Unios
® recommends a
phase-cut dimmer or DALI solution optimised for
LED technology.
For full list of compatible drivers, see unios.com
Output
Power
Driving
Current
Forward
Voltage
Product Code
MIRW0110
MIRW0162
350mA 32-38V
32-38V
13W
500mA18W
700mA25W
1000mA36W
Luminaire Compatibility
1
2x
2x
2
8
7
6
5
BB=A/3 C≤B
Luminaire
A
Side View Front View
C
A
SELV
240V 240V
4
3
2x
Click
Click
Click
Click
9
For more details see unios.com/miragespacing