FASTER INSTALLATION. 25-YEAR WARRANTY.
FLASHKIT PRO IS THE COMPLETE FLASHING AND ATTACHMENT SOLUTION FOR COMPOSITION ROOFS.
FOR QUESTIONS OR CUSTOMER SERVICE VISIT UNIRAC.COM OR CALL (505) 248-2702
PRE-INSTALL SYSTEM LAYOUT
• Locate rafters and snap horizontal and vertical lines to mark the
installation position for each ashing.
• Drill a pilot hole (1/4" diameter) for the lag bolt. Backll with sealant.
STEP 1 INSTALL FLASHKIT PRO FLASHING
• Insert the ashing so the top part is under the next row of shingles
and pushed far enough upslope to prevent water inltration through
vertical joint in shingles.
• The leading edge of ashing must butt against upper row of nails to
prevent turning when torqued.
QUICK TIP:
• For vertical adjustment when leading edge of ashing hits nails in
upper shingle courses, slide ashing up under shingles until leading
edge engages nails. Measure remaining distance to adjust upslope.
• Remove ashing and cut a "V" notch at marks where nail shafts
engaged leading edge of ashing the distance desired in Step 1.
Notch depth not to exceed 2" in length by 1/2" in width.
• Re-install ashing with notched area upslope, and position notched
leading edge underneath nail heads.
STEP 2 INSTALL L-FOOT
• Line up pilot hole with FLASHKIT PRO fastener hole.
• Insert the lag bolt through the EPDM washer, the top L-101-3
compression bracket, and the gasketed hole in the ashing and into
the rafter.
• Torque to 100-140 torque inch-pounds depending on the type of
wood and time of year. The visual indicator for proper torque is when
the EPDM on the underside of the bonded washer begins to push out
the sides as the washer compresses. If using an impact wrench to
install the fasteners be careful not to over torque the fastener. You
may need to stop and use a ratchet to nish the install.
STEP 3 ATTACH L-FOOT TO RAIL
• Slide the 3/8"-16 racking hardware into rail slot, spacing bolts to
match the spacing of the attachments.
• Torque 3/8" nut to 30ft-lbs. Use anti-seize to prevent galling.
• If attaching L-Foot to light rail, ensure the L-Foot does not
protrude above the top edge of the rail.
INSTALL FLASHKIT PRO FLASHING
STEP 1 STEP 2 STEP 3
INSTALL L-FOOT ATTACH L-FOOT TO RAIL
FEATURING TECHNOLOGY
FLASHKIT PRO
INSTALLATION GUIDE
