Unova Intermec Norand 6642 User manual

Quickstart Guide
Registered trademark; Marca Registrada by Norand Corporation, Cedar Rapids, Iowa, U.S.A.
Intermec is a trademark of Intermec Technologies Corporation.
Copyright 1998 Intermec Technologies Corporation. All rights reserved.
Acknowledgements
Microsoft, MS, MSćDOS, Windows, and Windows 95 are registered trademarks and Visual Basic for Windows, and
Windows for Pen are trademarks of Microsoft Corporation. PowerQuest and EasyRestore are registered trademarks
of PowerQuest Corporation.
P/N 962-054-024
Revision A
December 1999
NORANDR6642
Pen Computer
P/N 962-054-024 Revision A
*962054024*
All manuals and user guides at all-guides.com
all-guides.com

PEN*KEY 6642 Quick Start Procedure
PEN*KEY 6642 COMPUTER
AC ADAPTER/CHARGER
AND POWER CORD
PEN STYLUS
SOFTWARE
LICENSE
PACKING LIST
Check to make sure the items shown
above were included in your shipment.
RESTORE
LICENSE
-Windows 98 Certificate of Authenticity (Software License)
-PowerQuest Easy Restore License
-AC Adapter P/N 871-006-030
-Pen P/N 871-006-040
1. Plug DC power cord from AC adapter into DC input connector located on edge
of 6642. Plug the AC plug from the power cord into an electrical outlet.
2. Place pen in holder. Press power button located on front under power LED.
. System will boot for the first time. This will take a few minutes.
4. The 6642 boots to Windows 98 and displays the default desktop.
5. After charging the batteries, run drvsetup.exe to install any drivers that you may need for
your implementation.
Drvsetup is located at c:\drvsetup on the 6642 hard drive.
BCAUTION: Use only the AC adapter P/N 871–219–030 supplied with the 6642. Use of other AC adapters or
AC adapter cords could result in fire or equipment damage.
"NOTE: The 6642 is shipped with a 125VAC, 3A, two–blade US–style power cord. If your local AC mains
power is greater than 125VAC, or if your AC mains receptacle requires a different style plug,
please procure an appropriately approved AC power cord locally. The mating plug style that is
required on the AC Adapter end of the AC power cord is IEC 320–C8.
BCAUTION: Use only the expansion battery P/N 317–106–001 available for the 6642. Improper installation
and removal could result in fire or equipment damage.
"NOTE: The internal battery must be replaced by an Intermec service center, and the external battery
may be ordered separately. Spent batteries should not be placed in common household waste.
Contact local authorities for disposal in accordance with local regulations.
All manuals and user guides at all-guides.com