UPC 8400 User manual

PART Quantity Reference
Screws 16 H
Card Divider Clips 56 I
Header Clip 1J
Push Pins (Optional) 8K
PART Quantity Reference
Corner Posts 4A
Inserts 4B
Base 1C
Top Plate 1D
Wire Assembly Helper 1E
Card Racks 28 F
Headers (optional) 4G
IH KJ
E
F G
D
Pin on one
end only
C
ASSEMBLY INSTRUCTIONS
A
B
UPC 8400 84 Pocket Spinner
PARTS LIST
PARTS BAG
Revised 2/2/15 Page 1of 4
Finished Display
Bottom
View
TOOLS REQUIRED: #2 Phillips Screwdriver

Pin
Pin
B
A
C
H
Page 2 of 4
Attach the four Corner Posts (A), with pin ends down
to Base (C), using (8) Screws (H).
If using Laminate Inserts
Install (4) Laminate Inserts (B)
into Corner Posts (A)
(see Figure A below).
OR
If using Optional Corner Pockets (Card Wings)
Install according to directions included with
that product.
A
Figure A
ASSEMBLY
1

Figure 2
F
A
Figure 1
E
A
F
Figure 3
E
F
F
A
Page 3 of 4
Insert Wire Assembly-
Helper (E) into top of the
Corner Posts (A).
Be sure wire goes into
center holes (see Fig.1).
Peel off protective masking
on racks.
Insert Racks (F)
into narrow slots of the
Corner Posts (A) (see Fig. 2).
Be sure to engage the tabs
of the lower Racks (F) with
the slots in the upper
Racks (F) (see Fig. 3).
2
3
4
ASSEMBLY

Page 4 of 4
Assemble Header (G) using
Push Pins (K). Set Header (G)
into slots in top of Top Plate (D).
Remove masking from the adhesive strip
on the underside of the Header Clip (J).
Place Header Clip (J) onto the center of
the Top Plate (D) and insert signage
into Header Clip (J).
NOTE: There are different header styles that are available, please follow the appropriate instructions.
Without removing the Wire Assembly Helper (E),
install Top Plate (D) over slots on top of
Racks (F) and attach with (8) Screws (H).
Install (56) Card Divider Clips (I) on front edges of
Card Racks (F).
Note: Do not remove Wire Assembly Helper.
H
K
J
D
E
F
D
D
G
I
A B
ASSEMBLY
5
6
7