UPC 0947 User manual

UPC #0947 4-Tier 24" Break Resistant PETG Card Rack
Revised 06/06/14 Page 1 of 2
PARTS LIST
G
F
F
PART Quantity Reference
Screw Post 2A
Slatwall Adapters 2B
#8 - 32 Hex Nuts 2C
Plastic Wall Toggler 2D
Philips Head Screws 2E
PARTS BAG
PART Quantity Reference
Rack 1F
Divider 3 G
ASSEMBLY INSTRUCTIONS
Align hole in Slatwall Adapter (B) with
back side of hole in Rack (F). Prongs extend
back toward Slatwall and up. Attach using
Screw Post (A) from front and Nut (C)
on back.
Slatwall Assembly
Insert Divider (G) into
Rack (F).
1
G
B
C
A
B
C
A
2
NOTE: Assemble for EITHER Slatwall or Drywall, not both.
TOOLS REQUIRED: Flathead Screwdriver (Slatwall)
Drill with 3/8” Drywall Bit & Phillips Screwdriver (Drywall)
AB
C
E
D

Page 2 of 2
D
D
Place Rack (F) against Wall Toggler (D)
and insert Screw (E),
tightening until secure.
12
Drywall Assembly
WALLWALL
WALLWALL
D
E
F
G
Insert Divider (G) into
Rack (F).
3
D
F
E
E
NOTE: Assemble for EITHER Slatwall or Drywall, not both.
Determine position on wall
and drill 3/8" holes using drill and
3/8” drywall bit. Squeeze
Wall Toggler (D) flat and
insert into hole. Tap flange
flush with wall.