UPC 3536 User manual

Revised 09/14/15 Page 1 of 2
UPC #3536 47-3/4" 2-Tier PETG with 2/3 Exposure (2-Per)
ASSEMBLY INSTRUCTIONS
PARTS BAG
PARTS LIST
Align hole in Slatwall Adapter (B) with
back side of hole in Rack (F). Prongs extend
back toward Slatwall and up. Attach using
Screw Post (A) from front and Nut (C)
on back.
Slatwall Assembly
Insert Card Clips (F) into
Rack (G).
1
2
NOTE: Assemble for EITHER Slatwall or Drywall, not both.
A
G
C
B
F
D
E
B
C
PART Quantity Reference
Screw Posts 6A
Slatwall Adapters 6B
Hex Nuts 6C
Wall Togglers 6D
Phillips Head Screws 6E
Card Clips 32 F
PART Quantity Reference
Rack 2G
A
B
C
A
B
C
A
F
G
TOOLS REQUIRED: Flathead Screwdriver (Slatwall)
Drill with 3/8” Drywall Bit & Phillips Screwdriver (Drywall)

G
G
E
D
E
D
E
D
Determine position on wall
and drill 3/8" hole.
Squeeze Wall Toggler (D) flat
and insert into hole.
Tap flange flush with wall.
Place Rack (F) against Toggler
and insert Screw (E),
tightening until secure.
12
Drywall Assembly
WALLWALL
WALLWALL
D
E
D
G
NOTE: Assemble for EITHER Slatwall or Drywall, not both.
Page 2 of 2
Insert Card Clips (F) into
Rack (G).
3
F