UPC Health Shield 14088 User manual

ASSEMBLY INSTRUCTIONS
#14088 / 14089 / 14090 / 14091 - Bar ShieldUPC HealthShield
Page 1 of 3
Revised 05/28/20
2
A
B
B
Thank you for your purchase of one of many fine HealthSheild products designed & manufactured
by UPC. We have made every effort to make your assembly easy, clear & hassle free. For more
information or if you have any questions contact customer service at 1-800-859-7442.
upcdisplays.com
PART LIST Quantity Reference
Foot 4 A
Bar Shield 1 B
Protective
Paper
Peel the Protective Paper from
both sides of the Bar Shield (B).
TM
TM

Page 2 of 3
ASSEMBLY
2
3
A
A
A
B
upcdisplays.com
Adhesive Pads Protective
Strips
Peel the (2) Protective Strips from
Adhesive Pads on (4) Feet (A).
Note: Be careful to not make contact with
adhesive pads to any surface other than
intended location as adhesive is extremely
strong and bonds instantly.
Attach (2) Feet (A) by rmly pressing
Adhesive Pads to Bar Shield (B) approximately 6”
from edge of Bar Shield (B) as shown.
Note: Make sure Feet
are even with Shield.
6”
Side View
Wall
Foot
Shield
Table
Note: It might be helpful to use a table
that is against a wall to ensure feet are
level and true as shown above.

Page 3 of 3
4
ASSEMBLY
upcdisplays.com
A
B
Adhesive Pads
Place remaining (2) Feet (A) by rmly
pressing Adhesive Pads to Bar Shield (B)
on opposite side as shown ensuring
proper alignment of (2) Feet (A).
Note: If only (2) Feet (A)
are necessary for installation,
skip this step.