URIDAN SUMS+ User manual

GHMA-10 Installation Instructions – May 2020 www.uridanaustralia.com.au
Installation Instructions
Parts List |
Fitting Kit |
1
x 87° bend
1
x uriLOCK 0
.
3 L
1 x uriCLEAN 0.5 L
1
x uriCLOTH
1 x Cover
1
x suction device
2 x screws fitting No. 4
1 x fitting No. 4
Note |
Installation of the uridan waterless urinal is very
simple.
If you are retrofitting existing flushing urinals with uridan
waterless urinals, please ensure that the sewer line is jetted
and clean of uric scale before installation. Please also
remove any existing s-trap to avoid double trapping the
urinal.
The uridan urinals work without water, and must be fitted
to a 50mm waste pipe. Installation should be carried out
by authorized plumbers in accordance with AZ/NZS3500.2.
PLEASE NOTE: The undiluted discharge from a waterless
urinal must not be transported through copper or copper
alloy pipework.

GHMA-10 Installation Instructions – May 2020 www.uridanaustralia.com.au
ADMIRAL MINI GHMA-10
glass reinforced plastic (GRP) | | horizontal waste
Installation
1. Mark holes for fitting No. 4 and secure on wall.
2. Insert extension pipe (D) on the 87 ° bend (C). Keep a distance of 100 mm from the wall to the middle
of the pipe. If neccessary shorten the extension pipe. Place the 87 ° bend with the extension pipe on the
outlet pipe.
3. Remove the 87 ° bend with the extension pipe and place on the waste trap.
4. Place the urinal with the pipe on the outlet pipe. Lift the urinal and position on fitting (4).
5. Fill the waste trap (B) with water.
6. Insert the stainless steel cover (A).
7. Pour 1 bottle uriLOCK ( 0.3 litre) over the cover.
8. Seal the gap between the wall and the urinal with silicon. Please Note: Do not put silicone on the lower
tip of the urinal!
Please leave customer care booklet, cleaning and maintenance instructions,
cleaning spray, cleaning cloth and suction device with customer.
100mm