Vangoa LED-500 User manual
4. Alwaysreplace the caps on the fog liquid container immediately after
filling to
avoid contamination.
5.
If you experience low output, pumpnoise or no output at all, unplug immediately.
Check fluid level, the externalfuse, and power from the wall. If all of the above
appears to be O.K., plug the unit again. If fog does not come outafter holding the
remote button down for 30 seconds, check the hose attached to the tank to make
sure there is fluid going through the hose. If you are unable to determine the cause
of the problem, do not simply continue pushing the remote button, as this may
damage the unit.Please turn to us for help.
Performance Note
All fogmachines develop condensation around the output nozzle. Because this may
result in some moisture accumulation on the surface below the output nozzle, consider
this condensation when installing your unit.
All fog machines may sputter small amounts of fog occasionally during operation
andfor aminute or so after being turned off.
All fogmachines have a recycling period after long bursts when the machine will
shut itself down for a short period in order to heat up again. During this time no
fog can be produced.
Cleaning andStorage
Do notallow the fog liquid to become contaminated. Alwaysreplace the caps on
the fog liquid container and the fog machine liquid tank immediately after filling.
Cleaning your fog machine regularly can help you to reduce the frequency of parts
replacementand the cost of maintenance. After every 40 hoursof continuous
operation, it is recommended to use distilled water to clean the heater as per
following steps:
The recommended cleaning regimen is as follows:
1.
Fill proper distilled water into a clean tank and connect the fluid tube of the
fog
machine to the tank.
2. Run the unit in a well-ventilated areauntil the tank is almost empty.
3.
Use dry cloth to wipe the fog machine. Cleaning is now complete. Refill with fog
liquid.Run the machine briefly to clear any remaining liquid from the pumpandheater.
Note:
All fogmachines are prone to clogging due to the thick consistency of fog liquid and
the hightemperature at whichit vaporizes. However, a properly maintained fog
machine should provide years of reliable use.
Clean with A Dry Cloth Only, Store It in A Cool Dry Place
If the fogmachine is not in use, please clean it before storage. Store the fogmachine
in a dry and cool place. At least operate the fog machine once a month. A test-run
consisits of warming-up the machine followed by a few minutes of fog emission.
User Manual
Mini Fog Machine
Please read this manual carefully before operation
If you have any questions, please feel free to contact us:
Website: www.vangoa.com Facebook: @vangoaofficial
Made in China
Instagram: @
vangoa_music
ATTENTION：
Thank you for choosing Vangoa Fog Machine. Prior to use, we suggest that
you carefully read all of the instructions. Please follow these operation, safety
and maintenance instructions to ensure a long and safe life for your fog machine.
CAUTION:
Risk of electric shock. Disconnect the appliance from the electric supply
before refilling liquid, cleaning or performing maintenance on the machine.
Danger of Electric Shock
1. Keep this device dry.
2. For inside use only. Not designed for outside use.
3.
For all models, use 3-prong grounded electrical outlet only. Prior to use take
care to determine that the unit is installed at the rated voltage.
4. Always unplug the Fog Machine before filling its tank.
5. Always keep fog machine in upright position.
6. Turn off or unplug the machine when not in use.
7.
This machine is not water-proof. If moisture, water, or fog fluid gets inside
the housing, immediately unplug the unit and contact a service technician or
Vangoa before using it again.
8.
No user serviceable parts inside. Refer to Vangoa or other qualified service
personnel.
Danger of Burns
1.
This device is for adult use only and must be installed out of the reach of
children. Never leave the unit running unattended.
2. Never aim the output nozzle directly at people.
3.
Fog machine output is very hot. Avoid coming within 50 cm of the output
nozzle during operation.
4.
Locate the fog machine in a well-ventilated area. Never cover the unit's
vents. In order to guarantee adequate ventilation, allow a free air space of
at least 20 cm around the sides and top of the unit.
5.
Never aim the output nozzle at open flames. If the supply cord is damaged,
it must be replaced by manufacturer or its service agent or similarly qualified
personnel in order to avoid a hazard.
6.
The output nozzle becomes very hot during operation (200°C). Keep flammable
materials at least 100 cm away from the fog machine. (Don’t touch the machine
when it is operating, the surface is up to 40-80°C)
7.
Always allow the Fog Machine to cool down before attempting to clean or service it.
Danger of Explosion
1.
Never add flammable liquids of any kind (such as oil, gas, perfume) to the fog liquid.
2.
Use only high-quality, water-based fog liquid. Other fog liquids may cause
clogging or “spitting”.
3.
Always make sure there is sufficient liquid in the tank. Operating this unit without
liquid will cause damage to the pump as well as over-heating of the heater.
4.
If the FogMachine failstowork properly, discontinue use immediately.
Drain all fog liquid from the tank, pack the unit securely (preferably
in the original packing material), and reach Vangoa for service.
5. Always drain tank before mailing or transporting this unit.
6.
Never drink fog liquid. If it is ingested, call adoctor immediately.
If fog liquid comes incontact with skin or eyes, rinse thoroughly with
water. Pay attention to all warning labels and instructions printed on
the exterior of Vangoa Fog Machine.
Unpacking & Inspection
1.
Unbox to check whether all necessary spare parts include accord the
specification list. Please contact us if there are something missed.
2.
Check the appearance of machine and power line to see whether they
have some obvious damage. In the event that the unit's housing or
cableis damaged, do not plug it in and do not attempt to use it until
after contacting us for assistance.
3.
Please contact usonce you find anything problematic and stop to
use fog machine.
Setup
1.
Remove all packing materials from shipping box. Check that all
foam and plastic padding is removed, especiallyin the nozzle area.
2. Place fog machine on aflat surface andremove fog liquid tank cap.
3. Place the liquid tube into a properly filled liquid tank. Fill with
high-quality, water-based fog liquid. Poor qualityliquid can damage
the unit resulting in spitting and serious clogging problem.
4.
When filled, place cap back on liquid tank. Be careful not to exceed
the maximum fluid level.
5. DO NOT OVERFILL.
Operation
1. Plug power cord into a grounded electrical outlet.
2.
Turn the power switchto “ON” on the back of the machine. The unit
will start to warm-up the machine.
3.
During this time the machine cannot generate any fog. The redLED
of the receiver will light on andstay ON when the warm-up process
is complete.
4.
Pressunlock button, the machine will spray fog. Press the lock button
to stop spraying.
5.
You can place the machine in highposition using its hanger or place
it on the ground. Please do not allow the unit to have more than a 25
degree angle of inclination.
IMPORTANT:
1. Always monitor tank fluid level as you are fogging.
2. Never drink Fog liquid. If it is ingested, call a doctor immediately.
3.
If fog liquid comes in contact with skin or eyes, rinse thoroughly
withwater.
