Getting started
All goods must be checked prior to installation. If defects are found
due to manufacturing faults then goods MUST NOT be installed. The
merchant must inform the manufacturer.
If there is a proven manufacturing defect i.e. outside of tolerance and
the installation is carried out then, the manufacturer will replace the item
however the installation costs will be the responsibility of the installer.
02
Series I & II Mirror Cabinets
• When you receive your Shaving Cabinet you will note, when you
look at the back of the cabinet, that the back is screwed and
stapled.
• Please ensure you fix close to these screws when fixing to the wall
(see diagram).
• Make sure your fixings will be into studs or dwangs on each side
of the cabinet, top and bottom. If this is not possible then use
the appropriate rawl plugs or GIB fixing screws to suit your wall
material.
Cleaning & Maintenance
• Many commercial and household cleaners are acidic, alkali or
ammonia based. Cleaners that are acidic or alkali should be
avoided for mirror care and in particular those that boast double
strength ammonia. Ammonia can strip the protective copper
coating which can quickly and severely destroy a mirror.
• It is recommended that a chamois or soft cloth be dipped in warm
water and methylated spirits be used as a cleaning agent.
• Cleaning fluid should not be applied directly onto the mirror face,
as it could spill over the edges onto the back of the mirror or
form puddles at the bottom. Always apply the cleaning solution
to a cloth and wipe the mirror, ensuring all edges and joints are
thoroughly dry.
DO NOT USE ABRASIVE CLEANER SUCH AS STEEL WOOL ON THE
SURFACE AS IT MAY SCRATCH GLASS.
NOTE: REMOVE ALL
MOISTURE CAUSED BY
WET HANDS, STEAM OR
SPLASHES WITH A CHAMOIS
OR SOFT CLOTH AFTER USE.
Suggested fixings to pick up
studs.
Fixed Screws
