Vello BG-N23 User manual

USER’S MANUAL
BG-N23
BAT TERY GRIP
Designed for the
Nikon Z8
Mirrorless Camera

Thank you
for choosing Vello
The Vello BG-N23 battery grip offers extended shooting
time and comfort when shooting in a vertical (portrait)
orientation. The grip is compatible with the Nikon Z8
mirrorless camera, and it accepts up to two Nikon
EN-EL15c/EN-EL15b rechargeable batteries. You can
charge the batteries inside the grip without removing
them, and hot swap a battery while shooting video.
The BG-N23 offers an alternate shutter release, multi-
selector, and additional buttons, making the grip ideal for
shooting in portrait mode. The convenient control-lock
switch disables all the controls, preventing unwanted
exposures.
Please read through this entire manual
before using the BG-N23 battery grip.
2

Precautions
1. The BG-N23 should be used only with the compatible
devices specified in this manual.
2. Use only with the batteries and battery holders
recommended in this manual.
3. If you notice smoke, noise, or an unusual smell from
the battery pack, discontinue use immediately. Remove
the batteries, and take the device to a Vello authorized
reseller.
4. The battery level may not display properly if batteries
are installed before mounting the grip.
5. Remove batteries from the grip when not in use.
6. Do not attempt to disassemble.
7. Avoid exposing this product to water or extreme
humidity, and keep it in a cool, dry place.
8. Keep out of reach of children.
9. All images are for illustrative purposes only.
3
OVERVIEW INTRODUCTION
INSTRUCTIONS

Overview
3
4
11
12
18
19
21
17
20
5
9
67
16
15
14
13
8
123
10
222
4

1Nonslip grip
2Mounting screw
3Camera battery door holder
4Fn button
5Shutter release button
6Control lock
7Sub-command dial
8Tripod socket
9Battery tray release
10 USB-C™ port (charging only)
11 Door release button
12 Battery compartment door
13 Battery status LEDs
14 Rear thumbwheel
15 Multi-selector
16 Main command dial
17 AF-ON
18 Power contacts
19 Contact cover
20 Battery tray
21 Battery A release
22 Battery A compartment
23 Battery B compartment
5
INSTRUCTIONS OVERVIEW INTRODUCTION

Attaching the Battery Grip
1. Ensure that the camera
power is turned off, and
the grip’s control lock is in
the locked position.
2. Remove the camera’s
battery chamber door. Pull
gently at a 45° angle until the
door detaches.
3. Slide the chamber door
into the BG-N23’s camera
battery door holder for
safekeeping.
6

4. Insert the battery grip’s power contacts into the
camera’s battery chamber.
5. Rotate the rear thumbwheel counterclockwise
until the grip is secured to the camera.
7
OVERVIEW
INSTRUCTIONS INTRODUCTION

Inserting the Batteries
1. Turn off the camera’s
power, and make sure the
grip’s control lock switch is
in the locked position.
2. Press the battery door
release button and slide
the battery compartment
door open.
3. Press the battery tray
release and slide out the
battery tray.
2
11
2
8

4. Insert a battery into compartment A until it clicks
in place. Insert a battery into compartment B,
pushing inward and down into the compartment.
5. Insert the battery tray with compartment B first.
12
A
BB
9
OVERVIEW
INSTRUCTIONS INTRODUCTION

6. Close the compartment door,
and slide shut until it clicks.
7. Turn on the camera power,
and make sure the grip’s
control lock switch is in the
unlocked position.
Note: When removing the grip,
turn off the camera’s power and
lock the grip’s control lock switch,
and then remove the batteries.
2
1
10