Ventair Ultecon UT-M1 User manual

3 - Surface Wiring
5 - Completion WIRING DIAGRAM
4 - Wiring to Terminals
2 - Surface Mounting
Screws supplied
1 - Cover Removal
INSTALLATION INSTRUCTIONS
230V - 50Hz
Ultecon Thermostat UT-M1
Order Code: FAN5856
CAUTION:Isolatepower
supply and make safe
beforewiringthe unit
to prevent electric
shockandequipment
damage. Installation
should be carried out
byacompetentperson.

Distributed by: Ventair Pty Ltd
4 Capital Place, Carrum Downs, VIC, 3201, Australia
T: [phone] | E: [e-mail]
www.ventair.com.au
NOTE
• The thermostat requires 230V AC to operate.
• In order to correctly adjust the system to room temperature, install the thermostat as far
from heat sources, draughts or particularly cold walls (thermal bridges) as possible.
CAUTION
• Before wiring the appliance be sure to turn off the mains power.
• The appliance must be wired to the electric mains through a switch capable of
disconnecting voltage as per the current Australian safety standards.
• Installation and electrical wiring of this appliance must be made by a qualified technician
and in compliance with the current standards.
IMPORTANT
• Isolate the mains supply before making any electrical connections.
• This system should be installed by a qualified electrician.
• Thermostat should only be installed by fixed wiring, a flexible cord should not be used.
• The appliance is not intended for use by young children or infirm persons without
supervision.
• Young children should be supervised to ensure that they do not play with the appliance.
Specifications are subject to change without notice.