Venus Apollo User manual

Instructions Manual

Filling the herb chamber: Slide the glass tube outwards to
release the herb chamber. Fill the chamber. Tightly packed
chamber reduces performance. If you don’t want to fill the
chamber completely, you can adjust the depth of the chamber
by sliding the cooling unit in the glass tube. The cooling unit
slides inside the chamber as much as you wish. When the
chamber is placed back on the heating element, press down
the glass tube for a good contact with the chamber.
Start the heating: Place your finger on the boost button
and hold for a second (top button on the lighter coloured
wood). Apollo will vibrate and red LED activates to signal it
woke up from sleep mode and is ready for the turn on gesture.
Lift up your finger and swipe upwards from the bottom of
touch sense area. Apollo will turn on and starts to heat up. 2
LEDs will be active during the heat up period and once the
vape is ready the second led will turn off.

Power level adjustment: After heat up is done, you can
adjust the power level by swiping upwards or downwards.
Apollo will signal the chosen level from 1 to 10 by vibrations
and flashing of leds. Level 4 is recommended for most user.
Boost: Whenever you wish to have instant high power, just
hold the boost. Boost keeps the vape in optimal temperature
when the user is inhaling and more energy is needed. But be
careful, too much boost can lead to combustion of the
material, you will learn the correct way quickly. Especially
when the maximum boost setting is used, it can be easily
overdone.
Turn off: just press the boost button 5 times within 2 seconds
and the vape will turn off. Removing the battery cap naturally
also turns off the vaporizer
Adjusting the boost power/HerbSense: Wake up the
device by holding boost. Lift up your finger, swipe downwards
4 times within 2 seconds, and all 3 leds will be active. Now you
can press a button to choose the power level for boost:
bottom button = Low Power, middle button Max power, Boost
button = default level. After 10 seconds the vaporizer assumes
you didn’t want to change the boost power and flashes and
vibrates once to signal that time passed and now you can
enable(default) or disable the HerbSense feature.
Bottom button disables, middle button enables HerbSense.
(HerbSense reduces power level according to an algorithm
when the user doesn’t boost for sometime, and helps to
prevent baking of herbs during relaxed sessions.Disabling
feature makes Apollo 100% manually controllable for the fans
of full control.

Adjusting of heat up period: The temperature in the
beginning of a session is determined by the time of heat up
period, power level adjustment doesn’t have any effect on
heat up temperature. It can be changed easily. Have a
stopwatch ready to measure the time elapsed. Activate the
adjustment mode by holding boost, lift up the finger and swipe
downwards 4 times. All 3 lights will be active. Start the
stopwatch same time, and once the correct time has passed
just hold the boost button, and the vaporizer will save the new
time.
Battery level: When you insert the batteries, the 3 leds will
show the battery level according to the table below.
Caution: The herb chamber is made of stainless steel
and it is very hot during and after a session. Be careful!
For more information, tips, and troubleshooting please visit
www.venusvaporizers.com/blogs/extended-manual/apollo
Wishing You pleasant vapors!
www.venusvaporizers.com