Versa Desk Ultralite User manual

With your Desktop Riser on a desk or table, locate the cable underneath the unit’s top surface.
Connect that cable to the power supply included, and then plug the unit into a power outlet.
Push the button to raise the top surface of your desk riser to the maximum height.
UPDOWN
1
2
3Locate the 4 thumb screws in plastic bag (the shape of the thumb screws may be different
from the diagram. Insert the 4 thumb screws half way leaving a 1/4” gap between the thumb
screw and the bottom of the top surface.
VERSA DESK ®
1 [phone] [email protected]
Assembly Instructions

Secure the side brackets to the top surface by fully tightening all 4 thumb screws.
Slide the keyboard tray brackets into the gap between the thumb screws and the top surface.
Make sure the keyboard tray is all the way in and the end of the keyboard tray is sitting under
the middle bracket.
6
5
4Pick up the keyboard surface at an angle, align the slots on the side brackets to meet the
loosened thumb screws on both sides, passing the brackets behind the front plate until they
touch the underside of the top surface. Once the slots are right next to the thumb screws,
angle the keyboard surface back to a horizontal position.
VERSA DESK ®
1 [phone] [email protected]
Assembly Instructions