P
O
W
ER
650 850 1050 1250
Adjustable watch holder
+ =
TPD switch
Direction switch
Power switch
Holder extender Watch holder
ITEM: G084
* If you do not use this product for a long time, please switch off the unit.
* Make sure to turn the unit off completely before attempting to pull out the watch holder.
Instruction Manual
Thank you for purchasing a Versa watch winder
.
Please take a few minutes to read through the manual to ensure proper operation.
Please keep the instruction manual for future reference.
Specification
Power
Size
Weight
Temperature
Accessory
AC adapter DC/4V 550mA
5.24 x 6.26 x 5.79 inch (W x H x D)
About 1.30 Ib (without adapter)
Operate between 41°F ~ 104°F
AC adapter
Put the watch holder extender on the watch holder for larger size wrist watch
Feature
Wind clockwise, counterclockwise, Auto(bi-directional) by operating the switch.
TPD (Turns Per Day)
650TPD - 850TPD - 1050TPD - 1250TPD
Please note that the watch winder will turn, rest, and turn again for each setting.
The watch winder will not turn constantly to prevent over winding of your watch.
This is the normal operation for the watch winder.
1.
2.
Operation
Insert the adapter into the socket located on the product and plug it into the electrical outlet.
Open the front cover, then use your index finger and thumb to hold the watch holder from the two sides of the
holder hitch marked with two arrows. With some force, pull out the watch holder.
Place the watch on the holder by pushing in the spring on the back of the holder, then put your watch around the
holder and let go of the spring.
Once the watch is on the holder, place the holder back into the winder. Push until you hear a click signifying that
it is securely in the winder.
Press Power switch to start using the winder.
Slide Direction switch to select clockwise, counterclockwise or Auto(bi-directional) winding direction.
Slide TPD switch to select the TPD .
1.
2.
3.
4.
5.
6.
7.
Attention
NOTE
* Please use the AC adapter supplied with the unit. Input: AC/100-240V, 50-60Hz Output: DC/4V 550mA
* Remove the adapter when the winder is not in use.
* Always turn off the the power when inserting or removing watches.
* Don’t shake the watch winder when the winder is in operation.
Counterclockwise AutoClockwise
Place the watch holder into
the winder.
Push until you hear a "CLICK"
signifying that it is securely in
the winder.
Cover
