1. Fasten the first panel or connected set or panels directly to the support.
2. Repeat progressing laterally (clip panel sections together before fastening to the
support for a perfect fit.)
Drywall and Wood
Tools:1/2in.*1/2in. Crown 20 Gouge Staples & Stapler (Not Included)
1. Fasten the first panel or connected panels directly to the
2. top of the wall or service. Use additional staples on the
3. top panel in each column hung.
2. Place 2 Staples on the edges of each panel, making your
3. way down to the bottom panel.
4. Repeat progressing laterally (clip panel sections together
5. before fastening to the support for a perfect ft.)
Concrete, Brick or Block
Tools: 3/16 in.*13/4 in. Washer Head Concrete Screw Anchors, Drill
Bit & Drill (Not Included)
1. Hold a single panel in place at the top of the wall or
surface. Then, using your drill and drill bit, drill one hole
in the top left & suitable square holes found on the
backing grid of the panel. Drill each hole approximately
1/4 inch deeper than the anchor screw being used.
2. Screw a washer head concrete anchor in each hole,
securing the panel to the surface.
3. Repeat processing downward til a single column is
complete ensuring the panels are securely fastened as you progress.
4. Repeat steps 1-3 until your installation is complete.
Metal/Aluminum
Tools: 3/4 in. Truss Head Self-Tapping Screws & Drill (Not
Included)
1. Hold a single panel in place at the top of the wall or
surface. Using your drill and 3/4 in self-tapping screws,
place a screw in the top left & suitable square holes found on the backing grid of
