Viash studios LAX Series User manual

Wall Mounted Desk
Assembly Instructions
All manuals and user guides at all-guides.com
all-guides.com

Wall Mounted Desk
Parts List
phillips screwdriver
(not included)
C
x 11
x 6
x 6B
x 12x 13
x 8Apencil / pen
(not included)
All manuals and user guides at all-guides.com

pencil the location of six holes to be
shown locations on the next page.
drilled. Drill a 1/2" hole at the six
32 1/4" to 33 1/4"
STEP 1
Use part 3 to locate placement of
the Wall Mounted Desk. Check
to ensure part is level. Mark with
3 x1
All manuals and user guides at all-guides.com

All manuals and user guides at all-guides.com

STEP 2
rotate back, pull tight
slide cap against wall
against wall
rotate toggle,
push through drilled holes
x 6B
bend back and forth,
break off ends
All manuals and user guides at all-guides.com

STEP 3
2
x 13
x 1
correct orientation
This side to wall.
A x8
All manuals and user guides at all-guides.com
all-guides.com

are installed.
toggle boltsC
STEP 4
Have someone hold the desk
in place while the six
C x6
LAX Wall Mounted Desk
Dry Wall /
Gypsum
Toggle in
wall
All manuals and user guides at all-guides.com

STEP 5
1 x1
Mounted Desk
Align cover at top and bottom
with routed groove in Wall
Align
All manuals and user guides at all-guides.com