Vibe Optisound Auto 8 User manual

LITEAIRAUTO8-V1
LITEAIRAUTO8A-V1
All manuals and user guides at all-guides.com

Please ensure that when installing this product the heatsink will not contact
with any materials that mat be damaged by heat such as upholstery or plastics.
All manuals and user guides at all-guides.com

Connect to +12V of battery with
attached 20 amp fuse
Connect to chassis ground of
vehicle Connect to chassis ground of
vehicle
Connect to speaker output
of headunit
R + white R - white / black
L + grey L - grey / black
Connect to RCA (low level) output
of headunit
Connect to supplied bass remote
NOTE: if the remote is not
connected the amplifier will default
to minimum frequency and
minimum gain setting
LITEAIRAUTO8A-V1
R L REM GND
+12V
RL
All manuals and user guides at all-guides.com

Connect to Speaker output of amplifier
NOTE: VIBE recomends the LiteAir Bass 1
amplifier as the perfect partner for the
LITEAIRAUTO8-V1
LITEAIRAUTO8-V1
All manuals and user guides at all-guides.com

The LiteAir Auto 8 subwoofer enclosure can be mounted in many different locations in the vehicle due to it’s shallow profile.
Below are a few examples of different mounting applications that are possible with the LiteAir Auto 8 subwoofer enclosures.
Rear of seat
Under seat
Side panel
All manuals and user guides at all-guides.com

Please follow the installation method below to secure the enclosure to your chosen mounting location.
Step 1: Fold out the steel mounting tabs from underneath the enclosure
Step 2: Secure the enclosure with 4 screws.
Note: Be sure to investigate your mounting area thoroughly for electrical wires, brake or fuel
lines or fuel tank to prevent causing any damage.
If you are unsure VIBE recommend that the enclosure is installed by an authorised VIBE dealer.
All manuals and user guides at all-guides.com

Terminals & controls
LITEAIRAUTO8-V1 LITEAIRAUTO8A-V1
1
7 2
34
6
8
95
1.
2.
3.
4.
5.
6.
7.
8.
9. Speaker terminal
Connect to the speaker output of the amplifier
All manuals and user guides at all-guides.com

LiteAir Optisound Auto 8
LiteAir Optisound Auto 8 active
Part Number: LITEAIRAUTO8-V1
Peak Power: 900 watts
RMS Power: 300 watts
Height: 80mm (excl grill)
Width: 285mm
Depth:
Impedance:
397mm
Part Number: LITEAIRAUTO8-V1
Peak Power: 900 watts
RMS Power: 300 watts
Height: 80mm (excl grill)
Width: 285mm
Depth: 395mm
20 amp
4 Ohms
Fuse rating:
All manuals and user guides at all-guides.com

20 amp fuse
All manuals and user guides at all-guides.com

All manuals and user guides at all-guides.com

All manuals and user guides at all-guides.com

All manuals and user guides at all-guides.com