VidaBox VidaMount VB VESA MNT FXS User manual

Fixed Surface VidaMount
INSTALLATION GUIDE
VB_VESA_MNT_FXS
VESA 100x100 & 75x75 compatible
Ideal for VidaMount VESA Tablet Enclosures

1 Assemble the Fixed Tube & VESA Mounting Plate
Install (4) M4x12 Philips “Flat-Head” /
Countersink Head Screws through the
VESA Mounting Plate, and into the top of
the Fixed Tube.
(4) M4x12 Philips “Flat-Head”
Countersink Head Screws
VESA Mounting
Plate
Fixed Tube
Installation Instructions
Fixed Surface Mount : VESA Compatible
VESA Mounting
Plate
Base
Plate
Fixed
Tube
(8) M4x12 Philips “Flat-Head”
Countersink Screws
(4) M4X8 Phillips
“Button” / Pan Head Screws
If charging is desired, please prepare the extension cable and/or charging solution for the VESA tablet rst.
Installing the charging solution / extension cable will be easier to do now than it will be to do later.
VESA : 75 x 75 (3" x 3") and 100 x 100 (4" x 4") compatible.
(4) M4x50 Socket
Head Cap Screw
(3) M5x30 Philips
“Flat-head”/ Countersink
Head Wood Screws
(4) M4 Washers
(4) M4 Nuts
M3 Hex
Wrench
2 Decide how the surface mount sould be secured
IMPORTANT: Mounting surface thickness cannot exceed 2.5”
OPTION 1 : On-Surface Mount
4mm (1/6”)
wood bit
A. Use Base Plate as a
drilling template
If needed, drill a 5/8” [16mm] hole in the center,
so that the USB cable can pass through the surface.
(3) M5x30 Philips
“Flat-head” /
Countersink Screws
Base Plate
(4) M4x12 Philips
“Flat Head”/
Countersink Screws
B. Mark the (3) top
surface holes

3 Install USB Cable / Wire Run 4 Install VESA-Ready Enclosure
[Continued] 2 Decide how the surface mount sould be secured
IMPORTANT: Mounting Surface thickness cannot exceed 2.5”
OPTION 2 : Behind-Surface Mount
4mm (1/6”)
wood bit
A. Use Base Plate as a
drilling template
B. Mark the (4)
thru holes
If needed, drill a 5/8” [16mm] hole in the
center, so that the USB cable can pass
through the surface.
Assemble with the base
piece, from
behind/beneath
the surface
M4 Washer
M4 Nut
M4X50 Socket Head Screws
Use M3 Allen Wrench to tighten
5 OPTIONAL : Install Kensington Lock
If using the Fixed Surface Mount
with a round base plate, or for
additional security, one may wish to
use the built-in Kensington security
slot with a compatible Kensington lock [not
included].
(4) M4X8 Phillips
“Button” /
Pan Head Screws
Kensington Security Slot
Kensington Lock
[Not included]