Vie Oli OLID2082 Manual

Instruction Guide
OLID2082
Sunrise Alarm Clock
With LED Lights

Caution
To ensure safe and proper use, read all safety information
before using the device. Only use with manufacturer-ap-
proved batteries, chargers, accessories, and supplies.
• READ CAREFULLY AND KEEP THIS MANUAL
• THIS IS NOT A TOY, Please keep away from children.
• Do not expose the unit to extreme temperatures (heat or
cold), open flames, humid conditions, or wet conditions.
• Do not submerge in water.
• Do not open this product or attempt to repair the unit
yourself should it not be working.
• Do not allow the USB ports, power jack or other inputs of
the device to be exposed to dust, or water, or come into
contact with any conductive materials such as liquids,
metallic powders, etc.
Questions & Support
If you have any questions or problems concerning this
product, please visit our website at customersupport123.com.
In the Box
• OLID2082 - Sunrise Alarm Clock (x1)
• Type-C USB Power Cable (x1)
• User Manual (x1)
Before You Begin...

Getting Started
Location of Controls
[SNOOZE/LIGHT]
Button
[ALARM]
ON/OFF
Back of
Clock
Clock
Display
Front of
Clock

Connecting to Power
Insert the small connector of the included USB power cable
into the power input port on the back of the clock. Insert the
large connector into the USB port on a computer or into a
compatible 5V/2A USB Power Adapter (not included) and
plug into a wall outlet.
The clock display will
turn on when the clock
is connected to power.
If the clock is disconnected from power, it will only save the
time and settings for 60 seconds.
Display Modes
Press the [UP] button on the back of the clock to switch
between clock display modes. Press the [SET] button to save
as the default mode.
• Mode 1 shows the time for 10 seconds and the date and
temperature for 2 seconds.
• Mode 2 shows the time, alarm, date and temp. at all times.
Setting the Time
1. Press the [SET] button until the time is displayed.
2. Press + hold the [SET] button to set the time. The time
hours will begin flashing. Press the [UP] and [DOWN]
buttons to adjust. The dot in the upper left corner of the
display will appear when the hour is in PM.
3. Press [SET] to save the hour setting. The minute digits will
begin flashing. Press the [UP] and [DOWN] buttons to
adjust, and press [SET] to save. The clock will return to its
default display mode.
INPUT
5V/2A
See the last page of the manual for Bedside Light instructions.

Setting the Alarm Time
1. Press the [ALARM] button to turn the alarm ON or OFF.
2. Press the [SET] button until the alarm time is displayed.
3. Press the [DOWN] button to turn the alarm ON or OFF. The
dot in the lower left corner of the clock display will appear
when the alarm is turned on.
3. When the alarm is turned on, press + hold the [SET] button
to set the alarm time. The alarm hours will begin flashing.
Press the [UP] and [DOWN] buttons to adjust.
4. Press [SET] to save the alarm hour setting. The alarm
minute digits will begin flashing. Press the [UP] and
[DOWN] buttons to adjust, and press [SET] to save. The
clock will return to its default display mode.
Setting the Date
1. Press the [SET] button until the date is displayed.
2. Press + hold the [SET] button to set the date. The year will
begin flashing. Press the [UP] and [DOWN] buttons to
adjust.
3. Press [SET] to save the year setting. The month will begin
flashing. Press the [UP] and [DOWN] buttons to adjust, and
press [SET] to save the month.
4. The day will begin flashing. Press the [UP] and [DOWN]
buttons to adjust, and press [SET] to save. The clock will
return to default display mode.
Changing Temperature Units
1. Press the [SET] button until the temperature is displayed.
2. Press the [DOWN] button to switch between degrees
Fahrenheit (° F) and Celcius (° C).
3. Press [SET] to save. The clock will return to default display
mode.

Using the Bedside Light
• Press the [SNOOZE/LIGHT] button on the top of the clock
to turn the bedside light ON in white light mode.
• Press the [SNOOZE/LIGHT] button to adjust the light
brightness between low, medium and high.
• Press and hold the [SNOOZE/LIGHT] button to switch to
color-changing light mode.
• In color-changing light mode, press the [SNOOZE/LIGHT]
button to choose a light color.
• Press and hold the [SNOOZE/LIGHT] button to switch back
to white light mode. Note: the bedside can only be powered
OFF from white light mode.
Note: The bedside light cannot be used when the clock is in
sunrise mode and snooze mode.
Using the Sunrise Light
The clock’s sunrise light function will turn on 20 minutes
before your alarm time, and gradually increase in brightness
until your alarm goes off.
To use the sunrise light, set the alarm before you go to sleep.
Snooze Function
• Press the [SNOOZE/LIGHT] button when the alarm goes off
to activated the Snooze function. The alarm will ring again in
5 minutes. The sunrise light will continue to shine at full
brightness during the snooze time.
• To turn the alarm and sunrise light off completely, press and
hold the [SNOOZE/LIGHT] button when the alarm goes off.
This only turns them off for the day, and they will activate
again as normal the next day.
Using the USB Power Output
You can power or charge a USB device using the USB power
output port on the back of the clock.
To use, simply plug your device’s USB connector into the USB
power port while the clock is connected to power.

Compliance Information
FCC Information
This device complies with Part 15 of the FCC Rules.
Caution: Any changes or modifications not expressly approved could void
the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one
or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Radiation Exposure Information
This device has been evaluated to meet general RF exposure
requirements. The device can be used in portable exposure conditions
without restriction.
Rating Label Definitions
This symbol represents FCC Declaration of Conformity and compliance.
Direct current symbol

Warranty Information
Printed in China/Designed in the U.S.
v1. 02/2022
All product names, trademarks, and registered trademarks are property of their
respective owners. All company, product, and service names used in this document are
for identification purposes only. Use of these names, trademarks, and brands does not
imply endorsement.
90-Day Limited Warranty
Territory: United States/Canada
LIMITED WARRANTY TO ORIGINAL CONSUMER
This product as supplied and distributed new by an authorized retailer is warranted by
Southern Telecom, Inc. to the original consumer purchaser against defects in materials
and workmanship (“Warranty”) as follows:
To obtain warranty service:
• Visit our customer support portal: www.customersupport123.com
• Select the brand and model of your device
• Select “Service Request” and fill out the form to begin your inquiry
• Exchanges require dated proof of purchase from an authorized retailer
Your product will be repaired or replaced, at our option, for the same or similar model of
equal value if examination by the service center determines this product is defective.
Products received damaged as a result of shipping will require you to file a claim with
the carrier.
Warranty service not provided
This warranty does not cover damage resulting from accident, misuse, abuse, improper
installation or operation, lack of reasonable care, unauthorized modification including
software modifications such as the installation of custom firmware. This warranty is
voided in the event any unauthorized person opens, alters or repairs this product. All
products being returned to the authorized service center for repair must be suitably
packaged.
NO WARRANTIES, WHETHER EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED
TO, ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A
PARTICULAR PURPOSE, OTHER THAN THOSE EXPRESSLY DESCRIBED ABOVE
SHALL APPLY. DISTRIBUTOR FURTHER DISCLAIMS ALL WARRANTIES AFTER THE
EXPRESS WARRANTY PERIOD STATED ABOVE. NO OTHER EXPRESS WARRANTY OR
GUARANTY GIVEN BY ANY PERSON, FIRM OR ENTITY WITH RESPECT TO THE
PRODUCT SHALL BE BINDING ON DISTRIBUTOR. REPAIR, REPLACEMENT, OR
REFUND OF THE ORIGINAL PURCHASE PRICE - AT DISTRIBUTOR’S SOLE
DISCRETION - ARE THE EXCLUSIVE REMEDIES OF THE CONSUMER. IN NO EVENT
WILL DISTRIBUTOR OR ITS MANUFACTURERS BE LIABLE FOR ANY INCIDENTAL,
DIRECT, INDIRECT, SPECIAL, PUNITIVE OR CONSEQUENTIAL DAMAGES (SUCH AS,
BUT NOT LIMITED TO, DAMAGES FOR LOSS OF PROFITS, BUSINESS, SAVINGS, DATA
OR RECORDS) CAUSED BY THE USE, MISUSE OR INABILITY TO USE THE PRODUCT.
EXCEPT AS STATED HEREIN, NO OTHER WARRANTIES SHALL APPLY.
NOTWITHSTANDING THE FOREGOING, CONSUMER’S RECOVERY AGAINST
DISTRIBUTOR SHALL NOT EXCEED THE PURCHASE PRICE OF THE PRODUCT SOLD
BY DISTRIBUTOR. THIS WARRANTY SHALL NOT EXTEND TO ANYONE OTHER THAN
THE ORIGINAL CONSUMER WHO PURCHASED THE PRODUCT AND IS NOT
TRANSFERABLE.
Some countries, states or provinces do not allow the exclusion or limitation of incidental
or consequential damages or allow limitations on warranties, so limitation or exclusions
may not apply to you. This warranty gives you specific legal rights, and you may have
other rights that vary from state to state or province to province. Contact your
authorized retailer to determine if another warranty applies.