Viking Ve-light Instructions for use

VE-LIGHT

Enclosure Lighting

Kit

December 16, 2011

Power: 120V AC/12V DC 500mA, UL listed adapter provided or

use any 12-24V AC or DC source @ 50mA

Dimensions: 127mm x 8mm x 25mm (5” x 3” x 1”)

Environmental: -26°C to 54°C (-15°F to 130°F) with 5% to 95%

non-condensing humidity

Shipping Weights: 0.45 kg (1 lb)

Maximum Power Run: 304m (1000 ft) using 24 AWG wire

Material: 24 gauge Marine Grade 316 stainless steel

Add Panel Lighting to Your

Viking Doorbox or Entry Phone

The VE-LIGHT kit adds bright LED illumination to any

doorbox or entry phone that is housed in a Viking VE-

5x5, VE-6x7 or VE-5x10 enclosure. It can also be

used on Viking’s E-1600A-BLT-EWP tower phone.

The stainless steel bracket is easily mounted using

existing holes and hardware. Two bright white LEDs

are used as the light source, so there are no filaments

to break or bulbs to burn out.

If used with the W-1000, W-3000 or W-3005, the VE-

LIGHT can be wired directly to the AC power input of

the doorbox, or use the included 12 volt power supply.

Any power source between 12 and 24 volts, AC or DC

can be used to supply the VE-LIGHT with power.

TECHNICAL

• Ultra bright LEDs for long life

• Easy retro-fit to existing entry phones

• Can use the same power source as doorbox

• Can be powered from 12 to 24 volts AC or DC

VE-LIGHT shown above with Viking W-3000

and VE-5x5 (not included)

• The VE-LIGHT is designed to be used in conjunction with

the following products:

Model

E-10A/EWP

E-30/EWP

E-30-PT/EWP

E-35/EWP

E-1600-20A/EWP

E-1600-30A/EWP

E-1600A-BLT-EWP

E-1600A-BLT2-EWP

K-1200

K-1200-EWP

K-1205

K-1205-EWP

K-1500-7

K-1700-3/EWP

K-1705-3/EWP

K-1900-7/EWP

K-1900-8/EWP

W-1000/EWP

W-3000/EWP

W-3005

DOD#

210

212

214

178

215

217

182

183

352

157

159

364

362

170

180

181

VE Model

VE-5x5 / SS

(included)

VE-5x10 / SS

VE-6x7 / SS

VE-5x10 / SS

VE-5x5 / SS

IMPORTANT: Electronic devices are

susceptible to lightning and power

station electrical surges from both the

AC outlet and the telephone line. It is recom-

mended that a surge protector be installed to

protect against such surges. Contact Panamax

at (800) 472-5555 or Electronic Specialists Inc.

at (800) 225-4876.

IF YOU HAVE A PROBLEM WITH A VIKING PRODUCT, PLEASE CONTACT: VIKING TECHNICAL SUPPORT AT (715) 386-8666

Our Technical Support Department is available for assistance Monday 8am-4pm and Tuesday-Friday 8am - 5pm central time. So that we can give you better service, before you call please:

1. Know the model number, the serial number and what software version you have (see serial label).

2. Have your Technical Practice in front of you.

3. It is best if you are on site.

RETURNING PRODUCT FOR EXCHANGE

The following procedure is for equipment that has failed out-of-box (within 10 days of purchase):

1. Customer must contact Viking’s Technical Support at 715-386-8666 to determine possible causes for the problem. The

customer MUST be able to step through recommended tests for diagnosis.

2. If the Technical Support Product Specialist determines that the equipment is defective based on the customer's input

and troubleshooting, a Return Authorization (R.A.) number will be issued. This number is valid for fourteen (14)

calendar days from the date of issue.

3. After obtaining the R.A. number, return the approved equipment to your distributor, referencing the R.A. number. Your

distributor will then replace the product over the counter at no charge. The distributor will then return the product to

Viking using the same R.A. number.

4. The distributor will NOT exchange this product without first obtaining the R.A. number from you. If you haven't

followed the steps listed in 1, 2 and 3, be aware that you will have to pay a restocking charge.

RETURNING PRODUCT FOR REPAIR

The following procedure is for equipment that needs repair:

1. Customer must contact Viking's Technical Support Department at 715-386-8666 to obtain a Return Authorization (RA)

number. The customer MUST have a complete description of the problem, with all pertinent information regarding the

defect, such as options set, conditions, symptoms, methods to duplicate problem, frequency of failure, etc.

2. Packing: Return equipment in original box or in proper packing so that damage will not occur while in transit. Static

sensitive equipment such as a circuit board should be in an anti-static bag, sandwiched between foam and individual-

ly boxed. All equipment should be wrapped to avoid packing material lodging in or sticking to the equipment. Include

ALL parts of the equipment. C.O.D. or freight collect shipments cannot be accepted. Ship cartons prepaid to:

Viking Electronics, 1531 Industrial Street, Hudson, WI 54016

3. Return shipping address: Be sure to include your return shipping address inside the box. We cannot ship to a PO Box.

4. RA number on carton: In large printing, write the R.A. number on the outside of each carton being returned.

Due to the dynamic nature of the product design, the information contained in this document is subject to change without notice. Viking Electronics, and its affiliates and/or subsidiaries

assume no responsibility for errors and omissions contained in this information. Revisions of this document or new editions of it may be issued to incorporate such changes.

DOD# 428

ZF301930 Rev B

Printed in the U.S.A.

Step 1. Disconnect power from the doorbox or phone.

Step 2. Remove the doorbox or phone from the surface mount box (VE-5X5, VE-6X7, VE-5x10 or E-1600A-BLT-EWP).

Step 3. Connect the two wires from the VE-LIGHT to the power input terminals of the doorbox or use the included power

supply and wire nuts (see Diagram 1). Note: Wires can be connected in either polarity.

Step 4. Place the VE-LIGHT bracket against the upper mounting lip of the surface mount box and route wires through the

provided slot (see Diagram 1).

Step 5. Carefully place the phone or doorbox back into the surface mount box, making sure the wires stay in the slot

(see Diagram 2).

V A

2V D

apte

(

included

)

Wire Nuts

(included)

Rear View o

Doorbo

(

not included

)

VE-LI

Wir

routed throu

h th

rov

irin

hown

-1

000

/EWP

-3000/EWP

Wirin

hown

-1

-30/EW

-30-PT

-1

600

-2

EWP

-1600-30A/EWP

E-

1600

A-BLT-EWP

K-17

EWP

Phone or Doorbox

(W-1000 shown, not included)

Call

Surface Mount Box

(VE-5x5 shown, not included)

VE-LIGHT

Diagram 1

Diagram 2 !

LIMITED WARRANTY

Viking warrants its products to be free from defects in the workmanship or materials, under normal use and service, for a period of one year from the date of purchase from any authorized Viking distributor or 18 months from the date manu-

factured, which ever is greater. If at any time during the warranty period, the product is deemed defective or malfunctions, return the product to Viking Electronics, Inc., 1531 Industrial Street, Hudson, WI., 54016. Customer must contact Viking's

Technical Support Department at 715-386-8666 to obtain a Return Authorization (R.A.) number.

This warranty does not cover any damage to the product due to lightning, over voltage, under voltage, accident, misuse, abuse, negligence or any damage caused by use of the product by the purchaser or others. This warranty does not cover

non-EWP products that have been exposed to wet or corrosive environments.

NO OTHER WARRANTIES. VIKING MAKES NO WARRANTIES RELATING TO ITS PRODUCTS OTHER THAN AS DESCRIBED ABOVE AND DISCLAIMS ANY EXPRESS OR IMPLIED WARRANTIES OR MERCHANTABILITY OR FIT-

NESS FOR ANY PARTICULAR PURPOSE.

EXCLUSION OF CONSEQUENTIAL DAMAGES. VIKING SHALL NOT, UNDER ANY CIRCUMSTANCES, BE LIABLE TO PURCHASER, OR ANY OTHER PARTY, FOR CONSEQUENTIAL, INCIDENTAL, SPECIAL OR EXEMPLARY DAM-

AGES ARISING OUT OF OR RELATED TO THE SALE OR USE OF THE PRODUCT SOLD HEREUNDER.

EXCLUSIVE REMEDY AND LIMITATION OF LIABILITY. WHETHER IN AN ACTION BASED ON CONTRACT, TORT (INCLUDING NEGLIGENCE OR STRICT LIABILITY) OR ANY OTHER LEGAL THEORY, ANY LIABILITY OF VIKING SHALL

BE LIMITED TO REPAIR OR REPLACEMENT OF THE PRODUCT, OR AT VIKING'S OPTION, REFUND OF THE PURCHASE PRICE AS THE EXCLUSIVE REMEDY AND ANY LIABILITY OF VIKING SHALL BE SO LIMITED.

IT IS EXPRESSLY UNDERSTOOD AND AGREED THAT EACH AND EVERY PROVISION OF THIS AGREEMENT WHICH PROVIDES FOR DISCLAIMER OF WARRANTIES, EXCLUSION OF CONSEQUENTIAL DAMAGES, AND EXCLU-

SIVE REMEDY AND LIMITATION OF LIABILITY, ARE SEVERABLE FROM ANY OTHER PROVISION AND EACH PROVISION IS A SEPARABLE AND INDEPENDENT ELEMENT OF RISK ALLOCATION AND IS INTENDED TO BE ENFORCED

AS SUCH.

Other Viking Rack & Stand manuals